Ardesto IH-2000 - Инструкция по эксплуатации - Страница 27

EN

27

Diagram 3: Installation using a stand

The heater may be installed on its own stand (available separately). Installation is 

easy using the brackets supplied following the diagrams below.

The heater incorporates a tip-over function which will cut the power if the unit 

detects an angle greater than 45°.

CAUTION:

•  Ensure mains power is OFF before commencing installation.
•  The supplied mains cable must not contact the top surface of the heater during 

operation.

•  Heater must not be located immediately below a socket outlet. Electrical con-

nections must be made outside of the footprint of the unit to avoid heat build-

up. If the heater is to be mounted on an incline (e.g. sloping roof ), ensure the 

electrical connection is located below the lowest end of the heater.

•  Joists, beams and rafters shall not be cut or notched to install the appliance.
•  This heater is not intended for ceiling-recessed installation. Do not install point-

ing directly downwards.

•  The identification mark and model reference should be visible after installation.
•  The heater must not be attached facing or close to any combustible material (eg, 

wood or PVC cladding, fascia or soffit) or other materials that could blow onto 

the heater.

•  The fixed wiring insulation coming into contact with parts with a temperature 

rise of greater than 50°C must be protected, for example, by sleeving having an 

appropriate temperature rating.

•  Exercise caution when siting the heater stand that the heater cannot accidental-

ly be touched, knocked-over or that the wire causes a tripping hazard.