Ardesto IH-2000 - Инструкция по эксплуатации - Страница 25

EN

25

Mediumwave Infrared heat is  characterised by a strong central  beam that dissi-

pates to a gentler intensity heated area outside the    central beam.
The  zone heated by  heater will increase in size the higher the heater is installed 

from the floor, but the warmth experienced from the heater will be lower.
The mounting height and intensity should reflect the intended use of the heater.
Mount the heater at a lower height in areas intended for low physical activity (for 

example a seating area) or areas subject to stronger airflow (outside or near open 

doors).
Mount heater higher where less intense warmth is needed (for example ware-

houses where workers are active or wear warm clothing).
For permanent installation (i.e. not using a stand), the heater must be located in a 

position to allow proper and efficient use but one that ensures hot parts are not 

touched
The recommended installation height of the heater is 2.4m to 3.5m (95”-138”) 

from the floor.

IMPORTANT:

 DO not mount heater below 2.4m if any kind of automated on/off 

controller is to be used.
Under no circumstances is the heater to be installed at less than 1.8m (71”) from 

the floor. Consideration should be given to any temporary or occasional additions 

such as stages or platforms and adjusted accordingly. For outdoor use, or other 

areas with air movement/wind the directional Infrared spread may reduce by 1/3 

to 1/2.
Wall/ceiling mount swivel brackets are provided with the heater which has been 

specifically designed to allow this product to be fitted to a wall or ceiling with ad-

equate clearances at the back of the unit. Do not mount the heater with any other 

bracket except those provided.
The sides and ends of the heater must always be  at least   500mm (19.6”) away 

from the nearest wall, ceiling or other structure.