Кнопки «вверх» и «вниз»; Charging the Earphones; Bluetooth FAQ - Shure SE215-K-UNI-EFS - Инструкция по эксплуатации - Страница 14

Shure Incorporated

14/25

Кнопки «вверх» и «вниз»

Увеличение/уменьшение громкости

Нажатие кнопки «+» или «–»

Следующая композиция

Нажатие и удержание кнопки «+», 3 секунды

Предыдущая композиция

Нажатие и удержание кнопки «–», 3 секунды

Проверка состояния батареи

Нажмите и удерживайте одновременно кнопки «+»

и «–»

Примечание. 

Ваш телефон может не поддерживать некоторые функции.

Charging the Earphones

Red LED indicates low battery.

1. Connect earphones to charging device using supplied cable.

2. LED is red while charging.

3. When earphones are charged, LED turns off.

Warning: 

Before charging, make sure the product is at room temperature, between 0 to 45°C (32 to 113°F).

Note: 

Use this product only with an agency approved power supply which meets local regulatory requirements 

(e.g., UL, CSA, VDE, CCC, INMETRO).

Bluetooth FAQ

For more information, or to view other Frequently Asked Questions, visit the Shure FAQ (https://www.shure.com/

americas/support/find-an-answer).

Remote + Mic, Telephony, Voice Command and In-App use

Q.) How do I pair my wireless Sound Isolating™ earphones with my device?

A.) With the wireless earphones OFF, activate pairing mode by holding center button for 7 seconds on the remote. 

Navigate to Bluetooth settings in the source device settings, and the device SHURE

BT1 should appear in 

available devices. Select, and your device should be paired.

Q.) How do I set up multi-point pairing? How do I change active devices?

A.) Multi-point pairing, a feature of Bluetooth 4, is set up automatically—pair a second device (power cycle by

holding the power button down until the earphones turn off, and again for 7 seconds to enter pairing mode). The 

playback between devices should be triggered by new activity (incoming call, new playback). If devices do not 

automatically recognize the wireless earphones as an output device, try manually disconnecting and connecting in 

device settings.