AL-KO Drain 7500 - Инструкция по эксплуатации - Страница 12

en

Instructions for use

12

DRAIN 7000 / 7500 / SUB 6500

Switching the pump on

see Fig. A

CAUTION!

The  immersion  pump  must  not  draw  in

any  solid  bodies.  Sand  and  other  abra-

sive materials in the conveying medium

will destroy the immersion pump.

1. Unwind the connection cable 

(2)

 completely.

2. Make sure that the electrical plug connection

is mounted in the area safe from flooding.

3. Change  the  terminal  position  and  adjust  the

switching points of the float switch 

(3)

 indivi-

dually.

4. Attach  the  cable  on  the  float  switch  to  the

pump housing securely.

➯

Recommended cable length on the float

switch approx. 120 mm

ADVICE

Use  a  suitable  plate  to  ensure  se-

cure  mounting  of  the  immersion

pump  on  muddy,  sandy  or  stony

ground.

5. Immerse the immersion pump in the convey-

ing medium slowly. Hold the immersion pump

at a slight angle to allow any air to escape.

6. Insert the mains plug into the plug socket.

➯

The immersion pump switches on auto-

matically  using  the  float  switch  when  a

specific  water  level  has  been  reached,

and switches off again if the water drops

below the switch-off height.

Switching the pump off

1 Remove the mains plug from the plug socket.

Pumping out to residual water level

CAUTION!

Monitor  the  pump  continuously  when

pumping  out  to  the  residual  water  level

and avoid the pump running dry. Take the

pump  out  of  service  when  the  residual

water level is reached by pulling out the

mains plug.

The  float  switch  must  be  operated  manually  to

pump to the residual water level:
1. Remove the mains plug from the plug socket.
2. Lay the float switch up and fix it in position.
3. Insert the mains plug into the plug socket. The

pump switches on and starts to feed.

ADVICE

If the water drops below the residual wa-

ter  level,  (under  10/40  mm),  the  pump

will  draw  air  in.  In  this  case,  the  pump

must be vented when the water level ri-

ses and before using it again.

MAINTENANCE AND CARE

Cleaning the pump

ADVICE

After  conveying  chlorine-containing

swimming pool water or fluids that leave

a residue, the pump must be flushed out

with clear water.

1. Clean  the  suction  slots  on  the  suction  foot  if

necessary with clear water.

STORAGE

ADVICE

In the event of a risk of frost, the system

must be drained completely.

DISPOSAL

Do not dispose of old

equipment,batteries or accumulators

as householdwaste!

Product, packaging, and accessories

were made with recyclable materials, and

should be disposed of accordingly.

HELP IN CASE OF MALFUNCTIONS

CAUTION!

Disconnect  the  mains  plug  before  any  fault  rectification  work!  Faults  in  the  electrical  system

must be rectified by a qualified electrician.