Kraft KF-MG2035BD - Инструкция по эксплуатации - Страница 26

26

MEAT GRINDER

USER GUIDE

6.  If  the  meat  grinder  will  not  be  used  for  a  long  time,  after  washing,  wipe  all  its  metal 

parts, knife and grates with a cloth slightly moistened with vegetable oil.

  ATTENTION!  Do  not  immerse  the  motor  unit  in  water  or  any  other  liquid,  or 

rinse it under the tap. Use only a damp cloth to clean the motor unit.

 ATTENTION! Do not wash the metal parts of the meat grinder in the dishwasher!

 ATTENTION!  Do  not  use  gasoline,  benzene,  thinners,  hot  water,  caustic  and 

abrasive cleaning agents, sharp metal or rough brushes, etc., so as not to damage 

the surface of the device. Do not use high pressure cleaners or steam cleaners, as 

penetrating moisture can cause electric shock.

 ATTENTION! Keep the device out of the reach of children!

TROUBLESHOOTING

During  operation,  if  malfunctions  are  detected  that  the  consumer  cannot  eliminate 

on their own, it is necessary to contact the service workshop. But before contacting the 
repair service, read this section. This list includes the most common cases that are not 
the result of poor assembly quality or poor-quality materials used in this device.

 ATTENTION! Before troubleshooting, it is necessary to disconnect the device 

from the power supply. Troubleshooting that is not presented in this manual should 

be carried out only by a qualified and competent specialist.

In case of malfunctions that are not prescribed in this manual, you should immediately 

contact  an  authorized  service  center,  specifying  the  type  of  problem  and  the  model  of 
your immersion meat grinder. Only original spare parts can be used for repairs. Unskilled 
repairs remove the device from warranty service.

Malfunction

Possible cause

Solution

The device does not turn on.

The device is not connected to the 
power supply.

Connect the device to the power 
supply.

The electrical outlet is faulty.

Plug the device into a working 
outlet.

When grinding products, a strong 
vibration of the device is felt.

The products are cut too large.

Cut the products smaller.

During the operation of the device, 
an extraneous smell appeared.

The device overheats during 
operation.

Reduce the time of continuous 
operation, increase the intervals 
between switching on the device.