Nilfisk MC 7P-195/1280 POSEIDON 7-67 FA 107145848 - Инструкция по эксплуатации - Страница 4

4

1)

 Options / model variants

Original instructions

MC 5M, MC 6P, MC 7P

Symbols used to mark 

instructions

1  Important safety instructions

For your own safety

The high-pressure cleaner may 
only be used by persons in-
structed in its use and who have 
been expressly authorised to do 
so.

Although extremely easy to op-
erate, children should not be al-
lowed to use the cleaner.

General

Use of the high-pressure clean-
er is subject to the applicable lo-
cal regulations.
Besides the operating instruc-
tions and the binding accident 
prevention regulations valid in 
the country of use, observe rec-
ognised regulations for safety 
and proper use.
Do not use any unsafe work 
techniques.

Transport

Transport of the high-pressure 
cleaner is easy on its large 
wheels. 

For safe transport in and on ve-
hicles we recommend to prevent 
the equipment from sliding and 
tilting by fixing it with belts.

For transport at temperatures 
around or below 0°C, anti-freeze 
should be drawn into the pump 
beforehand (see chapter 6). 

Before starting the cleaner

If your 3-phase cleaner was 
supplied without a plug, have 
it fitted with a suitable 3-phase 
plug with earth conductor, by an 
electrician.

Before use, check that the high-
pressure cleaner is safe and in 
proper condition. 
Regularly check whether the 
power cord is damaged or 
shows signs of ageing. 

Use the high-pressure cleaner 
only when the mains power lead 
is in a safe condition. (risk of 
electric shock if damaged!).

Check the rated voltage of the 
high-pressure cleaner before 
connecting it to the mains power 
supply. Ensure that the voltage 
shown on the rating plate corre-
sponds to the voltage of the lo-
cal mains power supply.
We strongly recommend that the 
power supply to the high pres-
sure cleaner be connected via a 
residual current circuit breaker. 
This device stops the supply of 
electricity if the leakage current 
to earth exceeds 30 mA for 30 
ms or it has an earth tester cir-
cuit.

Operate the cleaner only in an 
upright position!

Please observe the regulations 
and provisions applicable in 
your country. Before putting the 
high-pressure cleaner into ser-
vice, carry out a visual check of 
all the major components.

Safety instructions in these 
operating instructions which 
must be observed to prevent 
risks to persons are marked with 
this danger symbol.

Before starting up your high-
pressure washer for the first 
time, this instruction manual 
must be read through carefully. 
Save the instructions for later 
use.

This indicates tips and instruc-
tions to simplify work and to en-
sure safe operation.

This symbol is used to mark 
safety instructions that must be 
observed to prevent damage 
to the machine and its perfor-
mance.