Мойки высокого давления Karcher HDS 801 B - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
– 7
Open the water supply.
Set the temperature regulator to opera-
tions with cold/ hot water.
Start the engine according to the oper-
ating instructions of the engine manu-
facturer.
Press the lever on the hand spray gun.
Set thermostat to "Burner off" position.
Danger
Scalding danger!
Set thermostat to desired working tem-
perature. The burner is switched on.
Caution
Unsuitable detergents can cause damage
to the appliance and to the object to be
cleaned.
–
For considerate treatment of the envi-
ronment use detergent economically.
–
Observe the dosage and other instruc-
tions provided with these detergents.
–
Use only those detergents approved by
the manufacturer of the appliance.
–
Kärcher detergents ensure smooth
functioning. Please consult us or ask
for our catalogue or our detergent infor-
mation sheets.
Suspend end of suction hose in a con-
tainer filled with detergent.
Set nozzle to "CHEM".
Set dosing value for detergent to the
desired concentration.
–
Loosen the dirt:
Spray detergent economically and let it
work for 1...5 minutes but do not let it
dry up.
–
Remove the dirt:
Spray off loosened dirt with the high-
pressure jet.
Set dosing value for detergent to "0".
Open the hand spray gun and rinse the
appliance for at least 1 minute.
Release the lever on the trigger gun.
Note:
When the lever of the hand spray gun
is released, the engine continues to run at
zero speed. The water thus circulates with-
in the pump and gets heated. When the cyl-
inder head at the pump has reached the
maximum permissible tempertaure (80 °C),
the therm-valve on the pump opens and
lets out the hot water into the open.
Cooling can be hastened while using com-
pressed water from the water supply pipes:
Pull the lever of the hand spray gun for
2 - 3 minutes so that the circulating wa-
ter cools down the cylinder head.
Set dosing value for detergent to "0".
Open the hand spray gun and rinse the
appliance for at least 1 minute.
Danger
Danger of scalding by hot water. After oper-
ation with hot water, the device must be op-
erated with openend handgun with cold
water for at least two minutes.
After operating the water using saline water
(sea water), open the hand spray gun and
rinse the appliance for at least 2 - 3 minutes
using tap water.
Caution
Never stop the motor under full load when
the hand-spray gun is opened.
Set thermostat to "Burner off" position.
Rinse the device thoroughly for at least
30 seconds.
Release the lever on the trigger gun.
Motor regulates to reach dry run speed.
Set the key switch at the motor to "OFF".
Close fuel cock.
Shut off water supply.
Turning on the Appliance
Operating with cold water
Operating with hot water
Operation with detergent
Recommended cleaning method
After operation with detergent
Interrupting operation
After operation with detergent
Turn off the appliance
21
EN
