Мойки высокого давления Karcher HD 1040 B - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
– 3
The safety valve opens when the overflow
valve is defective.
The safety valve is set by the manufacturer
and sealed. Setting only by customer serv-
ice.
The safety thermostat switches off the mo-
tor when the maximum permissible temper-
ature has been exceeded.
In case of transport damage inform ven-
dor immediately
몇
Danger
Risk of injury! Device, tubes, high pressure
hose and connections must be in faultless
condition. Otherwise, the appliance must
not be used.
Check oil level of the high pressure
pump at the oil sight glass.
Do not operate the appliance if the oil level
has fallen below "MIN".
Add oil if required (see technical speci-
fications).
Follow the instructions given in the sec-
tion "Safety Notes"!
Read the operating instructions of the
engine manufacturer before start-up
and follow the safety instructions care-
fully.
Fill the fuel tank with unleaded petrol.
Do not use 2-speed mixture.
Check oil level of the engine.
Do not operate the appliance if the oil level
has fallen below "MIN".
If required, top up oil carefully.
Connect high pressure hose and spray
pipe to the hand spray gun.
Install the nozzle on the spray pipe in
such a way that the marking is on the top.
Tighten covering nut firmly.
Connect the high pressure hose to the
high pressure connection point of the
machine.
몇
Warning
Observe regulations of water supplier.
According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply
without a system separator. Use a
suitable system separator manufactured by
KÄRCHER; or, as an alternative, a system
separator as per EN 12729 Type BA. Water
flowing through a system separator is con-
sidered non-drinkable.
Caution
Always connect the system separator to
the water supply, never directly to the appli-
ance!
–
For connection values refer to technical
specifications
Connect the supply hose to the water
connection point of the machine and at
the water supply point (for e.g. a tap).
Open the water supply.
Note
The supply hose is not included.
Danger
Never suck in water from a drinking water
container. Never suck in liquids which con-
tain solvents like lacquer thinner, petrol, oil
or unfiltered water. The sealings within the
device are not solvent resistant. The spray
mist of solvents is highly inflammable, ex-
plosive and poisonous.
Connect suction hose (minimum diame-
ter 3/4“) with filter (accessory) to the
water connection point.
Set dosing value for detergent to "0".
Remove air from appliance before oper-
ation.
Safety valve
Safety thermostat at the pump
Start up
Check oil level of the high pressure
pump
Motor
Install hand spray gun
Water connection
Suck in water from vessel
14
EN
