Bosch AQT 40-13 06008A7500 - Инструкция по эксплуатации - Страница 13

 English | 

13

Bosch Power Tools

F 016 L70 995 | (16.12.13)

Do not overreach with the high pressure hose or move the 
pressure washer by pulling the hose, this could cause the ma-
chine to become unstable and fall over.

Do not kink or drive a motor vehicle over the high pressure 
hose. Do not expose the high pressure hose to sharp edges or 
corners.

Never use a roto nozzle to clean motor vehicles.

WARNING! 

The Patio Cleaners supplied are only intended to 

be used on flat surfaces! Do not attempt to use them on steps 
or vertical surfaces. Never attempt to touch the rotating noz-
zle while operating the machine!

Working advice for cleaning with detergents



Only use cleaning agents suitable specifically for high 
pressure washers.

We recommend that you use detergent sparingly for the sake 
of the environment. Observe the recommended dilution on 
the detergent label.

Recommended cleaning method

Step 1: Loosening dirt

Attach the High Pressure Foam nozzle or select the foam set-
ting on the 3 in 1 nozzle and spray on the detergent sparingly. 

Step 2: Removing dirt

Spray off the loosened dirt with the high-pressure spray.

Note: 

When cleaning a vertical surface spray off dirt/deter-

gent from the bottom and work in an upwards direction. Rinse 
from the top and work downwards.

Troubleshooting

Problem

Possible Cause

Corrective Action

Motor refuses to start

Plug not connected

Connect plug

Mains socket faulty

Use another socket

Fuse faulty / blown

Replace fuse

Extension cable damaged

Try without extension cable

Motor protector has activated

Allow to cool for 15 minutes

Frozen

Wait for pump/water supply hose/accessory to thaw

Motor stops

Fuse faulty / blown

Replace fuse

Wrong mains voltage

Check that mains voltage corresponds to specifica-
tions on the model tag

Motor protector has activated

Allow to cool for 15 minutes

Fuses blow

Fuses incorrectly rated

Change to a mains supply higher than the pressure 
washer amp consumption

Motor starts but no pressure Nozzle partly blocked

Clean nozzle

Motor “sounds” but fails to 
start

Insufficient power supply

Check that the voltage of the mains power supply 
line is the same as that on the plate.

Voltage loss due to use of extension cable Check characteristics of extension cable

Appliance not used for a long period of 
time

Contact your Bosch Service Centre

Problems with TSS (Total Stop System) 
device

Contact your Bosch Service Centre

Pressure pulsating

Air in the inlet water supply hose/pump

Allow pressure washer to run with open spray han-
dle and nozzle at low pressure until regular working 
pressure is obtained

Inadequate water supply

Check that the water supply corresponds to specifi-
cations. The minimum specification for the water 
supply hose is 1/2" or 13 mm diameter

Water filter blocked

Clean water filter

Water supply hoses squeezed

Straighten out kinked water supply hoses

High pressure hose too long

Remove high pressure extension hose. Retry (exten-
sion hose max. 7 m)

Pressure too low, but steady

Note: Several types of acces-
sory will normally deliver a 
lower pressure

Nozzle worn

Change the nozzle

Start/stop valve worn

Activate trigger five times in quick succession

OBJ_BUCH-1953-005.book  Page 13  Monday, December 16, 2013  1:37 PM