Bort BHR-2500R-Pro - Инструкция по эксплуатации - Страница 4

4

(See Figure2)

Figure 2 - Adjusting nozzle for fan pattern 

(not applicable on some nozzle)

A narrow stream has high impact force on the cleaning 

surface and results in maximum deep cleaning in a con-

centrated area. However, this narrow high impact spray 

must be used cautiously, as it may damage some sur-

faces.

Figure 3 - Narrow high impact stream

A wide fan pattern will distribute the impact of the water 

over a larger area, resulting in excellent cleaning action 

with a reduced risk of surface damage, Large surface 

areas can be cleaned more quickly using a wide fan pat-

tern.

Figure 4 - Wide fan pattern

NOZZLE CLEANING INSTRUCTIONS

A clogged or partially clogged nozzle can cause a sig-

nificant reduction of water coming out of the nozzle and 

cause the unit to pulsate while spraying. To clean out the 

nozzle:

• Turn off and unplug unit.

•  Turn off water supply. Relieve any pressure trapped in 

the hose by squeezing trigger 2-3 times.

• Separate lance from gun.

•  Rotate nozzle to the narrow stream setting. This opens 

up the fan blades.

•  Using included tip cleaner, or an unfolded paper clip, 

insert wire into the nozzle hole and move back and forth 

until debris is dislodged. (See Figure 5.)

Figure 5 - Insert tip cleaner in nozzle hole and move 

back and forth until debris is dislodged

Align holes on the bottom of the pressure cleaner as 

shown and tighten the 2 screws, and fit the wheel to the 

machine, as the fig.

CONNECTION

1.  Attach the high pressure hose to the pressure water 

outlet of the machine.

2.  Attach the spray handle to the high pressure hose. 

Prior to operating the machine please ensure that the 

high pressure hose has been completely uncoiled. 

Whilst the machine is in operation the hose MUST not 

loop.

3.  Mount the nozzle or any other equipment you want 

to use.

4.  Connect the machine to the water and power supplies.

INSTALLATION, ELECTRICAL 

AND WATER CONNECTIONS

1. pressure cleaner

2. water supply hose

3. water connection

4. water inlet

5. high pressure tube

6. water outlet(backside)

7. spray gun

8. power supply

* No. 2, 3, 8 are not included

PRE-OPERATION

ADJUSTING FAN PATTERN

The angle of spray coming out of the lance may be ad-

justed on some lances by rotating the nozzle. This will 

vary the spray pattern from approximately a 0° narrow 

high impact stream to a 60° wide fan spray.