ADA Ground Drill 7 - Инструкция по эксплуатации - Страница 23

MEASUREMENT FOUNDATION

Ground

Drill - 5/7

23

Always shut-off engine before fill the fuel tank. Open fuel tank slowly. After filling the fuel 

tank tight the tank cap. 

Always keep the instrument 3 m away from the place where you are going to fill the fuel tank. 

Clean the area around tank cap.

Starting engine

1. Move ignition starter switch to the ON position.(Pic.3) 

2. Push several times on the primer bulb (4) (If you have it). When using the primer bulb, allow 

the bulb to return completely to its original position between pushes. (Pic.4)

3. Pull return starter with a rapid full arm stroke.

4. After engine starts running, return throttle lever to the RUN position. Then pull again the 

return starter (Pic.5).

NOTE!

 If the engine fails to start, repeat these steps 2-3 times.

Drilling

1. Hold handle tight with both hands (Pic.6)

2. Place the auger on the place where you are going to drill and start the engine.

3.  If  you  feel  unnatural  vibrations  or  hear  unwanted  sounds,  stop  engine  and  check  the 

instrument.

4. Stop. Slow down the engine and move ignition starter switch to the STOP position. (Pic.7).

Pic.3

Pic.4