Kraft BD (W)-360QX - Инструкция по эксплуатации - Страница 22

22

М О Р О З И Л Ь Н Ы Й   Л А Р Ь

C H E S T   F R E E Z E R

Р У К О В О Д С Т В О   П О   Э К С П Л УАТА Ц И И   •   U S E R   G U I D E

•  Ensure  that  air  can  circulate  freely  around  the  back  of  the  cabinet.  To  ensure  best 

performance, if the appliance is positioned below an overhanging wall unit, the minimum 
distance  between  the  top  of  the  cabinet  and  the  wall  unit  must  be  at  least  100  mm. 
Ideally, however, the appliance should not be positioned below overhanging wall units. 

•  Accurate leveling is ensured by one or more adjust-able feet at the base of the cabinet.

 WARNING! It must be possible to disconnect the appliance from the mains 

power supply; the plug must ‘therefore be easily accessible after installation.

Electrical connection

Before plugging in, ensure that the voltage and frequency shown on the rating plate 

correspond to your domestic power supply. The appliance must be earthed. The power 
supply  cable  plug  is  provided  with  a  contact  for  this  purpose.  If  the  domestic  power 
supply  socket  is  not  earthed,  connect  the  appliance  to  a  separate  earth  in  compliance 
with current regulations, consulting a qualified electrician.

The  manufacturer  declines  all  responsibility  if  the  above  safety  precautions  are  not 

observed. This appliance complies with the E.E.C. Directives.

Operating procedure

 WARNING

•  Do not put hot on the plastic parts in the appliance.
•  Frozen food must not be re-frozen once it has been thawed out.
•  Store  pre-packed  frozen  food  in  accordance  with  the  frozen  food  manufacture  s 

instructions.

•  Appliance  s  manufactures  storage  recommendations  should  be  strictly  adhered  to. 

Refer to relevant instructions.

•  Do  not  place  carbonated  of  fizzy  drinks  in  the  freezer  compartment  as  it  creates 

pressure on the container, which may cause it to explode, resulting in damage to the 
appliance.

•  Ice lollies can cause frost burns if consumed straight from the appliance.

First use

Before  using  the  appliance  for  the  first  time,  wash  the  interior  and  all  internal 

accessories  with  lukewarm  water  and  some  neutral  soap  so  as  to  remove  the  typical 
smell of a brand new product, then dry thoroughly.

 IMPORTANT! Do not use detergents or abrasive powders, as these will 

damage the finish.

Temperature Setting

Set  the  temperature,  on  the  temperature  control  knob.  A  green  light  on  the  control 

panel indicates that the compressor is on and running.
The temperature is regulated by turning the thermostat to the appropriate position).

Correspondence of temperature conditions to temperature indicators: