Kraft BD (W)-360QX - Инструкция по эксплуатации - Страница 21

21

М О Р О З И Л Ь Н Ы Й   Л А Р Ь
C H E S T   F R E E Z E R

Р У К О В О Д С Т В О   П О   Э К С П Л УАТА Ц И И   •   U S E R   G U I D E

•  Make  sure  that  the  power  plug  is  not  squashed  or  damaged  by  the  back  of  the 

appliance. A squashed or damaged power plug may overheat and cause a fire.

•  Make sure that you can come to the mains plug of the appliance.
•  Do not pull the mains cable.
•  If  the  power  plug  socket  is  loose,  do  not  insert  the  power  plug.  There  is  a  risk  of 

electric shock or fire.

•  This appliance is heavy. Care should be taken when moving it.
•  Do not remove nor touch items from the freezer compartment if you hands are damp/

wet, as this could cause skin abrasions or frost/freezer burns.

•  Avoid prolonged exposure of the appliance to direct sunlight.

Service

Any  electrical  work  required  to  do  the  servicing  of  the  appliance  should  be  carried 

out by a qualified electrician or competent person. This product must be serviced by an 
authorized Service Center, and only genuine spare parts must be used.

Energy saving

•  Don’t put hot food in the appliance.
•  Don’t pack food close together as this prevents air circulating.
•  Make sure food don’t touch the back of the compartment(s).
•  If electricity goes off, don’t open the door(s).
•  Don’t open the door(s) frequently.
•  Don’t keep the door(s) open for too long time.
•  Don’t set the thermostat on exceeding cold temperatures.
•  Some accessaries, such as drawers, can be removed to get larger storage volume 

and lower energy consumption.

Installation and connection

 Important! For electrical connection carefully follow the instructions given in 

specific paragraphs.

•  Unpack  the  appliance  and  check  if  there  are  damages  on  it.  Do  not  connect  the 

appliance  if  it  is  damaged.  Report  possible  damages  immediately  to  the  place  you 
bought it. In that case retain packing.

•  It is advisable to wait at least four hours before connecting the appliance to allow the 

oil to flow back in the compressor.

•  Adequate  air  circulation  should  be  around  the  appliance,  lacking  this  leads  to 

overheating.  To  achieve  sufficient  ventilation  follow  the  instructions  relevant  to 
installation.

•  Wherever  possible  the  spacers  of  the  product  should  be  against  a  wall  to  avoid 

touching or catching warm parts (compressor, condenser) to prevent possible burn.

•  The appliance must not be located close to radiators or cookers. Make sure that the 

mains plug is accessible after the installation of the appliance.

Location

•  The appliance should be installed well away from sources of heat such as radiators, 

boilers, direct sunlight etc.