Biostar H610 - Инструкция по эксплуатации - Страница 32

32 | Chapter 4: Useful help

4.4

Troubleshooting

Probable

Solution

1. There is no power in the system. Power LED does 

not shine; the fan of the power supply does not work 

2. Indicator light on keyboard does not shine.

1. Make sure power cable is securely plugged in.

2. Replace cable.

3. Contact technical support.

System is inoperative. Keyboard lights are on, power 

indicator lights are lit, and hard drives are running.

Using even pressure on both ends of the DIMM, 

press down firmly until the module snaps into place.

System does not boot from a hard disk drive, but can 

be booted from optical drive.

1. Check cable running from disk to disk controller 

board. Make sure both ends are securely plugged in; 

check the drive type in the standard CMOS setup.

2. Backing up the hard drive is extremely important. 

All hard disks are capable of breaking down at any 

time.

System only boots from an optical drive. Hard disks 

can be read, applications can be used, but system 

fails to boot from a hard disk.

1. Back up data and applications files.  

2. Reformat the hard drive. Re-install applications 

and data using backup disks.

Screen message shows “Invalid Configuration” or 

“CMOS Failure.”

Review system’s equipment. Make sure correct 

information is in setup.

System cannot boot after user installs a second hard 

drive.

1. Set master/slave jumpers correctly.

2. Run SETUP program and select correct drive types. 

Call the drive manufacturers for compatibility with 

other drives.

CPU Overheated

If the system shutdown automatically after power on system for seconds, that means the CPU 

protection function has been activated.

When the CPU is over heated, the motherboard will shutdown automatically to avoid a 

damage of the CPU, and the system may not power on again. 

In this case, please double check:

1. The CPU cooler surface is placed evenly with the CPU surface.

2. CPU fan is rotated normally.

3. CPU fan speed is fulfilling with the CPU speed.

After confirmed, please follow steps below to relief the CPU protection function.

1. Remove the power cord from power supply for seconds.

2. Wait for seconds.

3. Plug in the power cord and boot up the system.

Or you can:

1. Clear the CMOS data. (See “Close CMOS Header: JCMOS1” section)

2. Wait for seconds.

3. Power on the system again.