Beurer FM39 - Инструкция по эксплуатации - Страница 13

13

8. Start-up

• Remove the packaging.

• Check the device, power supply and cables for damage.

• Connect the device to the mains power supply.

• Route the cable safely so that there is no risk of anyone tripping over it.

9. Use  

When seated comfortably place your feet on the two platforms. 

The rubber feet on the base of the unit 

prevent it from sliding.

Switch on the massager with the ( ) button. Press the ( ) button again to activate the heat function. Press the  

( ) button repeatedly to switch the device off.

The massage must be pleasant and relaxing at all times. Stop the massage or change your position or the contact 

pressure if you find it is painful or unpleasant.

 Note

•   Do not use the massage device for longer than 15 minutes. Otherwise, using the device for longer can 

over-stimulate the muscles and cause tension instead of relaxation.

Massage of a specific point on the sole of the foot may influence the corresponding organ of the body. 

However, we recommend studying relevant literature and asking your doctor before using point reflex 

zone massage to achieve the desired effect.

10. Care and storage

Cleaning

 WARNING

•   Disconnect the device before cleaning it. 

•   Only clean the appliance in the manner specified. Fluid must never be allowed to enter into the device 

or accessories.

•   Clean the device with a slightly damp cloth. If it is very dirty, you can also moisten the cloth with a 

mild soapy solution.

•   Small marks can be removed using a cloth or damp sponge, and some liquid delicate laundry detergent 

where necessary. Do not use any solvent-based cleaning products.

• Do not use the device again until it is completely dry.

Storage

If you do not use the device for longer periods, we recommend storing it in the original packaging in a dry place 

without weighting it down.

11. In the event of problems

Problem

Cause

Remedy

Massage heads 

rotating at 

 reduced  speed.

The load on the massage 

heads is too great.

Release the massage heads. 

Massage heads 

not moving.

Appliance not connected to 

the power supply.

Connect the plug to the mains supply and switch on 

the appliance. 

Overheating protection 

tripped. 

Disconnect the device from the power supply, wait at 

least 15 minutes, then plug in again and switch on.

12. Technical specifications

Disposal 

220-240 V~, 50/60 Hz, 25 W