Машинки для стрижки Saturn ST-HC0365 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
4
If blade alignment is incorrect,
add a few drops of oil to the blades,
turn clipper on for a few moments,
turn off and unplug. Loosen screws
slightly and adjust. Tighten screws
after blade is aligned.
OIL
To maintain your clipper in peak
condition, the blades should be oiled
every few haircuts.
Do not use hair oil, grease, oil
mixed with kerosene or any solvent,
as the solvent will evaporate and leave
the thick oil, which may slow down the
blades motion.
BLADE LEVER
The lever is conveniently located
near your thumb (If you are right-
handed), so it can easily be adjusted
while the clipper is in your hand.
The lever adds versatility to your
clipper by allowing you to gradually
change the closeness of your cut with-
out an attachment comb.
When the lever is in the upper-
most position, the blades will give you
the closest cut and leave the hair very
short. Pushing the lever downward
gradually increases the cutting length.
In its lowest position, the lever
will leave the hair approximately the
same length as a No. 1 comb.
The lever will also extend the use
of your blades, since a different cut-
ting edge is used in each setting.
In addition, if extremely heavy
hair cutting has jammed the blades, it
will help you remove hair that has
become wedged between the two
blades without removing the blades.
While the clipper is running, rap-
idly move the lever from “close cut” to
“longer cut” a couple of times. Doing
this each time after you have finished
using your clipper, will help to keep
the blades clear of cut hair. If your
clipper stops cutting and this does not
help, your cutting blades are blunt.
Replace them with new blades.
IMPORTANT SAFEGUARDS
When using electrical appliances,
especially when children are present,
basic safety precautions should always
be followed, including the following:
To reduce the risk of death or injury
from electric shock:
Unplug this appliance before
cleaning.
Do not place or store appliance,
where it can fall or be pulled into a tub
or sink.
Do not use, while bathing or in a
shower.
Do not place in or drop into water
or other liquid.
Do not reach for an appliance that
has fallen into water. Unplug immedi-
ately.
To reduce the risk of burns, electrocu-
tion, fire or injury to persons.
Use this appliance only for its
intended use, as described in this
manual. Do not use attachments, not
