Remington HC550 - Инструкция по эксплуатации - Страница 8

8

and repeat on the other side of the head. Continue with the next pair of fade combs to 

blend between the next successive lengths.

5.  Use scissors to trim and cut hair on top of head, making sure to blend this into the 

length left at the upper zone.

Tips

•  Use the fade combs horizontally with the shortest comb tooth at the bottom down and 

longest tooth at the top.

•  Start with the longer part of the fade comb near the transition line to prevent taking off 

too much hair, move upwards until desired results are achieved.

CARE FOR YOUR HAIRCLIPPER

AFTER EACH USE

•  It is recommended that any accumulated hair be brushed out after each use.  1 or 2 

drops of clipper oil should be added to tip of blades, and a drop on the back gliding 

surfaces. 

CLEANING CAUTIONS

•  Ensure your clipper is switched off and disconnected from the charger before cleaning.

•  Brush the accumulated hair from the blades. Do not submerge the clipper in water.

•  To clean the unit, wipe with a damp cloth and dry immediately.

•  Note: Ensure the clipper is turned off when cleaning.

EVERY SIX MONTHS

•  At regular intervals the blade set should be removed and cleaned.

•  Remove the 2 screws retaining the fixed blade with a hex screwdriver. Do not remove 

blade set.

•  Brush out hairs from between the blades with soft cleaning brush. Do not remove the 

lubricating grease on the plastic components. It is not necessary to remove the small 

moving blade from the unit.

•  If the blades are not correctly aligned, cutting efficiency will be impaired.

•  Place a few drops of oil onto the blade’s gliding surface. Wipe off excess oil.

BATTERY REMOVAL

We strongly recommend that a professional removes the rechargeable battery. Parts of the 

shaver case, and tools have sharp edges and may cause injury if not handled correctly.

•  The rechargeable battery must be removed from the appliance before it is scrapped.

•  Disconnect the charging adapter before removing the battery.

1.  Turn the trimmer on and discharge all remaining power.

2.  Lift or pry the deco plate on the lower portion of the clipper and unscrew 2 screws 

located on the back housing of the clipper.

3.  Remove 4 screws of inner housing to expose batteries

ENGLISH