Remington HC363C - Инструкция по эксплуатации - Страница 7

5

GB

D

NL

F

E

I

DK

S

FIN

P

SK

CZ

HU

N

PL

RU

TR

RO

GR

SL

AE

HR/ SRB

GB

   Brush out hairs from between the blades with sof t cleaning brush. Do not remove the 

lubricating grease from the blades. It is not necessar y to remove the small moving blade 
from the unit .

   If the moving blade has been removed this can be re-fitted by slotting the ceramic blade 

holder over the pin in the centre of the interior product head. The groove on the ceramic 
blade, just below the teeth, rests on a metal plate at the opposite side to the screw holes. 
The fixed blade is fitted with the raised profile pointing outwards and fixed with the 2 
screws.

   Before fully tightening the 2 screws, adjust the taper lever to the lower position and align 

the blades so that their cutting edges are parallel to one another. Tighten the 2 screws.  
Note that if the blades are not correctly aligned then cutting ef ficiency will be impaired.

   Place a few drops of cutter or sewing machine oil onto the blades. Wipe of f excess oil.

 CAUTION : Do not use liquid cleaners on the blades or harsh or corrosive chemicals on 
the blade casing. Always use a sof t brush to remove the accumulated hairs.

   Unplug the charge adaptor from the power outlet when fitting or removing attachments, 

or while cleaning the product .

   Always store this appliance and cord in a moisture-free area. 
   Do not wrap the cord of the charging adaptor around the appliance.

TROUBLESHOOTING

If blades do not seem to cut hair easily, the taper lever ( PICTURE 6) can be used to remove 
any hair caught between the comb and blade. Switch the clipper on and move the taper lever 
up and down a few times but do not force the lever in either direction. This should remove 
hairs and restore the cutting ef ficiency. If not , contact your nearest Reming ton

®

 Ser vice 

Centre.

IMPORTANT SAFET Y INSTRUCTIONS

WARNING – TO REDUCE THE RISK OF BURN S , ELECTROCUTION , FIRE , OR 
INJURY TO PERSON S :

   An appliance should never be lef t unattended when plug ged into a power outlet .
   Keep the power plug and cord away from heated sur faces.
   Make sure the power plug and cord do not get wet . 
   Do not plug or unplug the shaver with wet hands.
   Do not use the product with a damaged cord. A replacement can be obtained via our 

International Ser vice Centres.

   Charge, use and store the product at a temperature between 15°C and 35°C .
   Always unplug from the mains when cleaning.
   Only use the par ts supplied with the appliance.

ENGLISH

080705_REM_IFU_HC363C_22L.indd   5

080705_REM_IFU_HC363C_22L.indd   5

03.11.2008   19:06:40 Uhr

03.11.2008   19:06:40 Uhr