Remington HC363C - Инструкция по эксплуатации - Страница 6

4

STEP 5 – The finishing touches – PICTURE 5

    Use the clipper without an attachment comb for close trimming around the base and sides 

of the neck. Use the ear comb guides to get a clean line around each ear. For the required 
ear comb guide, angle the clipper and lightly stroke around each ear to the back of the 
neck. 

    To produce a clean straight line at the sideburns, reverse the hair clipper. Place the 

reversed clipper at right angles to the head, tips of the blades lightly touching the skin and 
then work downwards.

   SHORT TAPERED ST YLES – “ FL AT TOPS” & SHORT CUTS

    Star ting with the longest guide comb attached (25mm) , cut from the back of the neck to 

the crown. Hold the guide comb flat against the head and slowly move the clipper through 
the hair, as shown. ( PICTURE 1) 

    Use the same procedure from the lower side to the upper side of the head, as illustrated. 

Then cut the hair against the direction in which it grows and level with the sides.
( PICTURE  3 )

    To give a “flat top” look, the hair on top of the head must be cut over the top of a flat 

comb.

    Use a closer guide comb to taper the hair down to the neckline as desired.

   TAPER LEVER

This product has a taper lever located a the lef t side of the clipper near the blades. Adjust 
the lever to change the closeness of the cut gradually and also to improve the ef fectiveness of 
the comb attachments. The taper lever also extends the life of the blades because a dif ferent 
cutting edge is used in each setting.

CARE FOR YOUR HAIRCLIPPER

Your clipper is fitted with high quality ceramic blades that are premanently lubricated. To 
ensure long lasting per formance of your clipper, clean the blades and unit regularly. Always 
keep the protective cap on the trimmer blade.

   AFTER EACH USE

   Ensure the clipper is switched of f and disconnected from the mains.
   Brush the accumulated hair from the blades. Do not submerge the clipper in water.
   To clean the unit , wipe with a damp cloth and dr y immediately.

 Note : Ensure that the clipper is turned of f when cleaning.

   EVERY SIX MONTH S

At regular inter vals the Blade Set should be removed and cleaned. 

   Remove the 2 screws retaining the fixed blade with a screwdriver.  Do not remove blade 

set .

ENGLISH

080705_REM_IFU_HC363C_22L.indd   4

080705_REM_IFU_HC363C_22L.indd   4

03.11.2008   19:06:40 Uhr

03.11.2008   19:06:40 Uhr