Panasonic ER-GP21 - Инструкция по эксплуатации - Страница 11

11

English

Troubleshooting

Problem

Action

The clipper has become 
blunt.

Operating time is short.

Clipper stopped 
functioning.

Until problems are solved, please 
follow each procedure as follows;
1.  Charge the clipper. 

(See page 8.)

2.  Clean the blade and apply oil. 

(See pages 9 and 10.)

3.  Replace the blade. 

(See page 9.)

4.  Have the battery replaced by an 

authorized service centre.

The clipper cannot be 
charged.

Push the main body into the charging 
stand or appliance plug all the way.
Charge within the recommended 
charging temperature of 0 °C to 
35 °C.

Makes a loud sound.

Apply oil.
(See page 10.)
Have the battery replaced by an 
authorized service centre.

If the problems still cannot be solved, contact the store where you 
purchased the appliance or a service centre authorised by 
Panasonic for repair.

Removing the built-in rechargeable battery

Remove the built-in rechargeable battery before disposing the 
clipper.

Please make sure that the battery is disposed of at an officially 
designated location if there is one.
This figure must only be used when disposing the clipper, and 
must not be used to repair it. If you dismantle the clipper yourself, 
it may cause malfunction.

• 

Remove the clipper from the AC adaptor.

• 

Slide the power switch to turn on the power and then keep the 
power on until the battery is completely discharged.

• 

Perform steps 

1

 to 

8

 and lift the battery, and then remove it.

• 

Take care not to short circuit the positive and negative terminals 
of the removed battery, and insulate the terminals by applying 
tape to them.

















For environmental protection and recycling of materials

This clipper contains a Nickel‑Metal Hydride battery.
Please make sure that the battery is disposed of at an officially 
assigned location, if there is one in your country.

ER-GP21_CIS.indb   11

2016/02/01   15:38:23