Машинки для стрижки HOTTEK HT-965-003 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
ENG
12
Blade Oiling
•
To maintain your hair clipper in peak condition, the blades should be oiled
using the engine oil.
•
Do not use hair oil, grease, oil mixed with kerosene or any solvent.
•
The solvent will evaporate and leave a thick oil which may slow down the
blades motion.
Blade Lever (5)
•
The blade lever (5) is conveniently located near your thumb (if you’re right-
handed) so it can be easily adjusted while the clipper is in your hand.
• The blade lever adds versatility to your clipper by allowing you to gradually
change the closeness of your cut without an attachment comb.
•
When the blade lever is in the uppermost position, the blades will give you
the closest cut and leave the hair very short. Pushing the lever downward
gradually increases the cutting length.
•
In its lowest position, the blade lever will leave the hair approximately the
same length as 6.1 attachment comb (3mm).
•
In its highest position, the blade lever will leave the hair approximately the
same length as 6.4 attachment comb (12mm).
•
The blade lever (5) will also extend the use of your blades since a different
cutting edge is used in each setting.
•
The blade lever (5) will help to remove hair that has stuck between the blades.
•
To remove stuck hair, move the blade lever (5) from lower to upper position
a couple of times.
•
If your hair clipper stops cutting and this does not help, your cutting blades
are dulled. Replace them with new blades.
Warning:
Clean the blades from hair when idle and after each haircut. This will
remove any and all remaining hair.
Before First Use
•
Before each use inspect the hair clipper and ensure that it is free from oil
between the cutting blade teeth.
•
Switch the hair clipper on to distribute the oil and to make sure it is running smoothly.
•
While using the appliance, untwist the cord from time to time to avoid tangling.
•
Seat a person so that his/her head is at your eyes level. This provides better
control of hair cutting.
•
Before cutting always carefully comb hair to ensure that there are no tangles.
•
Place a towel around the neck of a person having the haircut to avoid the
cut hair to fall under the collar.
Характеристики
Остались вопросы?Не нашли свой ответ в руководстве или возникли другие проблемы? Задайте свой вопрос в форме ниже с подробным описанием вашей ситуации, чтобы другие люди и специалисты смогли дать на него ответ. Если вы знаете как решить проблему другого человека, пожалуйста, подскажите ему :)
