Telefunken TF-CSRP3434 - Инструкция по эксплуатации - Страница 4

4

Instruction manual

4

Radio operation

•  Set the function switch to RADIO position.
•  Select your desired broadcasting band by 

setting the band switch to the desired position. 
AM of FM will be displayed.

•  Rotate TUNING regulator to tune to your 

desired radio station frequency. The radio 
frequency will be shown on the display.

•  Rotate VOLUME regulator to adjust sound 

volume level.

•  To turn off the radio set the function switch 

to OFF position.

Antenna

•  For FM reception, adjust the telescopic 

antenna appropriately to obtain the best 
reception on the band selected.

•  The AM signals are picked up through the 

built-in antenna. The set should be placed to 
an appropriate position for the best reception.

FM/FM stereo reception

•  In particular when stereo signal is weak 

and much noise are received, it is preferable 
to receive programs in mono mode. Set the 
band switch to FM ST position to receive radio 
programs in stereo mode.

•  If the program is received in FM stereo, 

“ST” indicator will light up.

Disc operations

Insertion and removal of discs

•  Pull up the CD compartment door. Place 

a disc into the compartment with the label-side 
(printed side of disc) facing upwards. Press 
down in the center part of disc until the disc 
locks onto the center spindle.

•  When the disc has been placed onto 

the center spindle, gently lower the CD-door 
downwards until it locks shut. The disc is now 
ready to be played.

•  When opening the CD-door, always 

ensure the disc is not in motion (not spinning) 

when you open the CD-door. Always press 
STOP button to stop the disc spinning first.

•  To remove the disc, follow the same 

procedure as described above, except to 
remove the disc instead of inserting it into the 
compartment, by placing one finger at the 
middle of disc (center spindle) and the other at 
the edge of the disc and gently pulling upwards.

  Always hold a disc by its edges. Avoid 

getting any fingerprints, smudges or dirt onto 
the surface of a disc. In case this happens, use 
a special CD-cleaning cloth or cleaning kit to 
remove the dirt or smudges.

Important:

 Please make sure to always fold 

down the handle before opening the CD door.

Compact disc operation

•  Set function switch to CD position.
•  Put a disc into the CD compartment and 

close the CD door.

•  The display will show the total number of 

tracks after a few seconds.

•  If there is no disc in the unit, the display 

will show “NO“. If the CD compartment door is 
not closed properly, the display shows “---“.

Play/pause mode

•  Press PLAY/PAUSE button to start 

playback, the display will show the current 
track number and playback symbol.

•  Press PLAY/PAUSE button to pause at 

any track when playing, playback symbol on 
the display flashes. Press this button again to 
resume playback.

•  To stop playback, press STOP button. The 

display will show the total number of tracks on 
the disc.

Skip and search mode

•  Press 

 SKIP/SEARCH button once 

to skip to the next track. Press and hold this 
button to search for a particular point at high 
speed forward. Release the button to resume 
normal playback.

•  Press 

 SKIP/SEARCH button once 

to skip to the beginning of the current track. 
Press 

 SKIP/SEARCH button twice to skip