Hyundai Electronics H-CDM8072 - Инструкция по эксплуатации - Страница 11

11

Operation

will seek to the next down or up strong and 
clear frequency station. Repeat this action to 
seek for other desired stations. 

Programming tuner stations

There are six numbered preset buttons on the 

panel and RC, under which you can store and 
recall stations for each band. Select the needed 
station, then press and hold a preset button. 
The station will be saved in the memory under 
the corresponding number. To recall a stored 
station, press the corresponding preset button.

Automatic store/preset scan

Automatic store
Press and hold F/PS button. The radio will 

automatically store the 6 strongest available 
stations to the 6 preset memories of the 3 FM or 
2 MW bands (depending on which is current). 
To stop auto store, press this button again.

Preset scan
Press F/PS button, the receiver will scan the 

saved stations in the current band.

Mono/Stereo control 

(in FM radio mode)

Press SEL button until the display shows 

STEREO (MONO). Turn VOLUME regulator on 
the panel or press VOL+/- buttons on the RC 
to switch between stereo reception or mono 
reception. Improvement of reception of distant 
stations can be done by selecting mono mode, 
which may cut down some reception noise.

Local radio station search

Press SEL button to choose LOCAL (DX). 

When the LOCAL function is on, the local 
stations (stations with weak radio signal) can 
be played. When the DX function is on both 
local and distant stations (stations with strong 
radio signal) can be played.

RDS function

RDS (Radio Data System) service availability 

varies with areas. Please understand if RDS 
service is not available in you area, the 
following service is not available, either.

AF (Alternative frequencies) function

Press AF button to turn the AF function on 

or off.

When radio signal strength is poor, enabling 

AF function will allow the unit to automatically 
search another station with the same PI 
(Program Identification) as current station but 
with a stronger signal, so that you do not have 
to retune the stations when driving between 
different transmitter coverage areas. When 
AF symbol is on, it means RDS information is 
received; when AF symbol is flashing, it means 
RDS information is not received.

PS (Program Service name): the name of 

station will be display instead of frequency.

If RDS service is not available in your area, 

turn off the AF mode. Default setting is ON.

TA (Traffic Alarm) function

Press TA button to turn TA function on or off.
In TA mode traffic program will be auto 

searched, until the program is received. 
When traffic announcement is received the 
unit will temporarily switch to the tuner mode 
(regardless of the current mode) and begin 
broadcasting the announcement. After the 
traffic announcement is over, it will return to the 
previous mode and volume level. To interrupt 
traffic announcement press TA button shortly; it 
will not switch off the TA mode.

PTY (Program Type)

This radio will allow you to select the type of 

program required, and will search for a station 
broadcasting that type of program. 

Press PTY/CLK button on the panel or PTY 

button on the RC to show the music type. Then 
press 1 - 6 number buttons to choose different 
music programs available.

Press PTY/CLK button on the panel or PTY 

button on the RC twice to show the speech 
type program. Then press 1 - 6 number 
buttons to choose different speech programs. 
Each number button will show 3 different 
speech programs for you to choose (see table 
below).