Hyundai Electronics H-CCR8091 - Инструкция по эксплуатации - Страница 10

Operation

10

Audio parameter setting

Press SELECT button repeatedly 

to select a parameter: VOL (volume) 
=> BAS (bass) => TRE (treble) => 
BAL (balance) => FAD (fader). Rotate 
VOLUME knob to adjust each mode:

•  Bass/Treble: from -6 to 6;
•  Balance: L06 (left) to R06 (right);
•  Fader: from R06 (rear) to F06 

(front).

  When equalizer is in any mode 

except FLAT, bass and treble are not 
adjustable.

Preset equalizer modes

Press SELECT button repeatedly 

until FLAT/ROCK/POP/CLASS or 
JAZZ equalizer mode is displayed. 
Rotate VOLUME regulator to select 
equalizer mode.

Clock

Press and hold CLK button to 

display the time on the screen. Then 
press and hold this button again; 
the hour indication will blink. Rotate 
VOLUME regulator to adjust hours; 
press CLK button to go to minutes; 
rotate VOLUME regulator to adjust 
minutes. To confirm the adjustment, 
press CLK button or leave the unit idle 
for several seconds.

Aux input

AUX-in jack is intended for 

connecting an external audio 
equipment to amplify the sound. If 
connection is made correctly, the 
audio signal from the external source 
will be translated through the acoustics 
of the head unit. This enables to 
adjust the volume and quality of the 

sounding. For example, you can 
connect an MP3-player to listen to 
tracks using the car acoustic system.

Radio operations

Band select

In Radio mode press BND/MEM 

button to select a radio band: F1 
(FM1), F2 (FM2), F3 (FM3). 6 stations 
can be saved in each band.

Manual/automatical tuning

•  Press 

/

 buttons 

repeatedly to adjust the needed 
frequency manually.

•  Press and hold 

 or 

button. The radio will seek to the next 
down or up strong and clear frequency 
station.

Storing and recalling stations

•  Press and hold APS/

button for more than 2 seconds 
to automatically find and store 6 
strongest stations in the current band.

•  After 6 strongest stations are 

saved, press APS/

 button; scanning 

of all stored stations will begin.

•  Press CH-/10- and CH+/10+ 

buttons to select saved channels. If 
you want to save a new station in a 
preset position, select corresponding 
station number with CH-/10- and 
CH+/10+ buttons. Then tune to the 
needed frequency as described in 
“Manual/automatical tuning“ above 
and press and hold BND/MEM button. 
The new frequency will be saved in 
the selected position.