FDUР 50401 - Инструкция по эксплуатации - Страница 18

         FDUP 50401

18

EN

Technical specifications

11. TECHNICAL SPECIFICATIONS

Speed .....................................................................................................................................2 400 rpm
Cutting depth in wood ........................................................................................................... 51 mm
Cutting depth in steel ............................................................................................................ . 4 mm
Pendulum positions 

0, I, II, III

Bevel angle .............................................................................................................................. 0°- 45°
Sound pressure level 

dB(A)

Sound power level 

dB(A)

Vibration level 

a

hB

 = 8.432 m/s

2

      K = 1.5 m/s

2

a

hM

 = 5.842 m/s

2

      K = 1.5 m/s

2

Changes in the text, design and technical speciÿ cations may change without prior 

notice and we reserve the right to make these changes.keep it from turning as the drill bit 

rotates.

Troubleshooting

1. The trigger is pressed but the device is not working: For the cordless device to work, you

need a su°ciently charged battery. The battery will go ˛at if you do not use the cordless 

device for an extended period of time. Try charging the battery. Check that the battery is 

correctly seated in the charger. The charger will heat up while charging, this is normal.

2. The battery is leaking: At extreme temperatures or when under extreme load, a small

amount of leakage may occur. If you happen to touch the ˛uid, immediately wash it o˝ 

your skin or clothing with soap and water.

3. The battery is not charging and the light on the charger is not lit: If the battery is not

charging, check that it is correctly seated in the charger and check that the indicator 

light is lit. If it is not lit, check that the power plug of the charger is correctly plugged into 

the socket. If it is, check the socket's fuse/circuit breaker.

4. The body of the device heats up a˙er extended use: Under normal load the body,

trigger and battery will heat up because the energy consumed when drilling generates 

heat. This is normal. Simply allow the device to cool down for several minutes.

5. The battery heats up during use: Energy drawn from the battery generates heat. It does

not damage the battery, heat from drawing energy is normal. If you wish to cool the 

battery down, allow the device to cool down for a few minutes before continuing with 

work.

6. The battery heats up while charging: This is normal and is the result of chemical

reactions taking place inside the battery during the charging process.

7. The charging unit will heat up while charging: This is normal and is caused by the

reduction of voltage from 230V to 18V.

Nominal voltage.....................................................................................................................18V 

DC

Instructions Manual - language version only. 

Amendments to text and technical parameters are reserved.