FDUР 50401 - Инструкция по эксплуатации - Страница 12

         FDUP 50401

12

EN

General safety instructions | Specific safety instructions

Service

Do not change parts of the tool, do not perform repairs on your own and do not interfere with
the tool’s construction in any way. Leave tool repairs to qualified persons.
Each repair or product modification performed without our company’s permission is
inadmissible (it can cause injury or harm to the user).
Always leave tools to be repaired in a certified service centre. Use only original or
recommended spare parts. This will ensure your and your tool’s safety.

5. SPECIFIC SAFETY INSTRUCTIONS

WARNING!

 Before use, please read these safety Instructions and store them with care.

Please ensure that the voltage of the mains power supply corresponds to the value stated on
the type plate. The tool is equipped with a two-pole lead and plug!
Wear safety glasses and a face or dust mask if the cutting or drilling operation is dusty.
When using the tool for extended periods, or where the noise level is high, use adequate 
hearing protection.
If devices are provided for the connection of dust extraction and collection facilities, ensure
these are connected and properly used. Always empty the dust collection bag when full.
Use clamps or a vice to hold the work piece. It is safer than using your hand and frees both
hands to operate the tool.
Ensure the power cord is arranged so that it cannot be tripped over, stepped on or have heavy
weights rested on it; and make sure that the cord will not be subjected to any damage.
A risk of injury exists in the case that instructions in this manual are not followed.
The jigsaw complies with valid technical regulations and norms.
When working with the jigsaw, the protective cover must always be pushed down.
Regularly check both screws on the clamp of the saw blade.
Do not use damaged or worn saw blades.
Regularly check the setting of the guide pulley.
Do not turn the saw on if the saw blade slid into the workpiece.
Never overload the saw so much that the engine ceases.
Never try to stop the movement of the saw blade, even when the engine is turned off.
The saw blade itself is removed very quickly. The blade’s teeth are very sharp.
Never aim the saw at another person.
Use protective gear against noise, dust and vibrations!!!

WARNING!

 Keep these safety instructions!!!