Bosch GST 150 CE (0601512000) - Инструкция по эксплуатации - Страница 12

12

 | English 

2 609 932 936 | (16.4.14)

Bosch Power Tools

Intended Use

The machine is intended for making separating cuts and cut-
outs in wood, plastic, metal, ceramic plates and rubber while 
resting firmly on the workpiece. It is suitable for straight and 
curved cuts with mitre angles to 45 °. The saw blade recom-
mendations are to be observed.

Technical Data

The technical data of the machine are listed in the table on 
page 182.

The values given are valid for a nominal voltage [U] of 230 V. 
For different voltages and models for specific countries, 
these values can vary.

Declaration of Conformity

We declare under our sole responsibility that the product de-
scribed under “Technical Data” is in conformity with the fol-
lowing standards or standardization documents: EN 60745 
according to the provisions of the directives 2011/65/EU, 
2004/108/EC, 2006/42/EC.

Technical file (2006/42/EC) at:
Robert Bosch GmbH, PT/ETM9,
D-70745 Leinfelden-Echterdingen

Robert Bosch GmbH, Power Tools Division 
D-70745 Leinfelden-Echterdingen 
Leinfelden, 18.03.2014

Noise/Vibration Information

The measured values of the machine are listed in the table on 
page 182.

Noise and vibrational values (vector sum of three directions) 
determined according to EN 60745.

The vibration level given in this information sheet has been 
measured in accordance with a standardised test given in 
EN 60745 and may be used to compare one tool with anoth-
er. It may be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main ap-
plications of the tool. However if the tool is used for different 
applications, with different accessories or insertion tools or is 
poorly maintained, the vibration emission may differ. This 
may significantly increase the exposure level over the total 
working period.
An estimation of the level of exposure to vibration should also 
take into account the times when the tool is switched off or 
when it is running but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total working 
period.
Identify additional safety measures to protect the operator 
from the effects of vibration such as: maintain the tool and the 
accessories, keep the hands warm, organisation of work pat-
terns.

Mounting and Operation

The following table indicates the action objectives for mounting and operation of the power tool. The instructions for each action 
objective are shown aside. Depending on the type of application, various instruction combinations are required. Observe the 
safety instructions.

Henk Becker
Executive Vice President
Engineering

Helmut Heinzelmann
Head of Product Certification
PT/ETM9

Action

Figure

Please observe

Page

Inserting the Saw Blade

1

183

Ejecting the Saw Blade

2

183

Switching on the sawdust blower 
device 

3

183

Connecting the dust extraction

4

184 – 185

OBJ_BUCH-1027-003.book  Page 12  Wednesday, April 16, 2014  10:14 AM