Timberk AC TIM 18HDN S19 - Инструкция по эксплуатации - Страница 9

www.timberk.com • Electric air conditioner

9

8. MAINTENANCE

•  Before cleaning unplug the conditioner.
•  Cleaning of the indoor unit and remote control board:
•  Indoor unit and remote control board should be cleaned with a dry soft cloth.
•  If the indoor unit is too unclean, moisten the cloth with cold water.
•  It  is prohibited to clean the remote control board with moist cloth.
•  In order to avoid the damage of paint or details of the conditioner, do not 

clean it with brushes and do not leave them on the surface of indoor unit.
•  In order to avoid the damage of surface or deformation of the conditioner 

details, do not clean it with petrol, solvents, cleaning powders or other 
chemically active substances.
•  Before a sustained interruption in the conditioner work:
•  Turn the conditioner on for several hours in the FAN mode. It will allow you 

to dry its inner cavities
•  Unplug the conditioner. Remove the batteries from the remote control board. 

Checks before starting:
•   Make sure that an air filter is installed.
•  Make sure that air inlet and outlet grilles of the outdoor unit are not blocked 

by foreign objects.
•  Cleaning of air filter
•  Air filter cleans the air entering the conditioner from dust and foreign particles. 

If the filter is contaminated, the conditioner capacity decreases sharply.

•  If the conditioner is operated permanently, the filter should be cleaned once 

per two weeks.
•  If the conditioner is installed in a room with dusty atmosphere, then the air 

filter should be cleaned more often.
•  To remove the filter, open the indoor unit panel.
•  Remove air filters. Clean the filter with a vacuum cleaner or rinse it in clean 

water. If the filter is contaminated heavily, clean it with a soft brush and wash in 

diluted washing solution, then dry it in a cool place.
•  While cleaning the filter with the vacuum cleaner, hold it with contaminated 

surface up. While washing the filter in water, hold it with contaminated surface 

down.
•  Do not dry the filter in the sun or near a fire.
•  Set the air filter to initial position and close the panel.

NOTE:
After installing the batteries in the remote control for 
a few seconds will alternately flashing heating and 
cooling. To select the mode of the console «cooling 
only» press any key on the remote control during 
display cooling mode. 
To select the operation mode of the remote control 
«cooling-heating» press any key during the display of 
the heating mode, or do not press any key to stop the 
flashing indicator.