Philips HD7404 - Инструкция по эксплуатации - Страница 7

  4 

 Clean the detachable parts (see chapter ‘Cleaning’).

  5 

 Flush the appliance (see section ‘Flushing the appliance below).

Flushing the appliance

  1 

 Open the lid of the coffee maker (Fig. 3).

  2 

 Fill the water tank with fresh cold water up to the MAX indication (Fig. 4).

  3 

 Put the jug on the hotplate.  (Fig. 5)

  4 

 Set the on/off switch to ‘I’ to switch on the appliance (Fig. 6).

,

The power-on light goes on.

  5 

 Let the appliance operate until all the water has run into the jug.

  6 

 Switch off the appliance. Let it cool down for at least 3 minutes before you start brewing 

coffee.

using the appliance

Brewing coffee

  1 

 Open the lid of the coffee maker (Fig. 3).

  2 

 Fill the water tank with fresh cold water up to the required level (Fig. 4).

You can brew 4 large cups (120ml) or 6 small cups (80ml) with a full water tank

Note: The lines on the water level window correspond to large cups.

  3 

 Take a paper filter (type 1x2 or no. 2) and fold the sealed edges to prevent tearing and 

folding (Fig. 7).

  4 

 Put the filter in the filter holder (Fig. 8).

Note: Some versions come with a permanent filter. In this case you do not need to use paper filters.

  5 

 Put ground coffee (filter-fine grind) in the filter (Fig. 9).

 - For large cups: use one heaped measuring spoon of ground coffee for each cup.

 - For small cups: use one level measuring spoon of ground coffee for each cup.

  6 

 Close the lid of the coffee maker.  (Fig. 10)

  7 

 Place the jug with the lid closed on the hotplate (Fig. 5).

Note: If you do not place the jug properly on the hotplate, the drip stop prevents the coffee from flowing 

into the jug. This may cause the filter to overflow.

  8 

 Set the on/off switch to ‘I’ to switch on the appliance (Fig. 6).

,

The power-on light goes on.

  9 

 Let the water pass through the filter into the jug.

Note: If you want to remove the jug during or after brewing, the drip-stop system prevents coffee from 

dripping through the filter onto the hotplate (Fig. 11).

 10 

 Put the jug with the remaining coffee back onto the hotplate to keep the coffee hot and to 

preserve its flavour.

 11 

 After use, set the on/off switch to ‘O’ to switch off the appliance.

Note: If you want to brew another jug of coffee right away, let the appliance cool down for 3 minutes 

first.

EnglisH

7