Clatronic KA 3756 - Инструкция по эксплуатации - Страница 37

KA3756_IM 

15.06.20

37

Electric Connection

1.  Ensure that your mains power corresponds with the 

specifications of the appliance. The specifications are 

printed on the type label.

2.  Connect the mains cable to a properly installed and 

earthed wall outlet.

Initial Operation

Before making coffee for the first time operate the appliance 

twice with clean water only and without paper filter. This 

removes dust, which may have collected during transport. 

Follow the instructions given under “Operation”.

Turning  the Appliance  On / Off

•  Press the “  ” switch in order to turn on the appliance. 

The button must snap in. The operating control lamp 

lights up.

•  Press the “   ” switch in order to turn off the appliance 

or to cancel the brewing process. The operating control 

lamp turns off.

Operation

1.  Open the lid of the water tank.

2.  Fill cold water according to the desired amount of cups 

of coffee into the rear water tank. You can determine the 

water level with the help of the scale in the water tank.

  NOTE:

You can use the pot to fill the water tank. To open 

the lid of the pot, press the two latching lugs together 

simultaneously.

  CAUTION:

Do not overfill the tank! Do not fill it above the MAX 

mark.

3. 

Insert the filter holder. One of the two handles must be 

on the right hand side and the other on the left. Push the 

filter holder down until it snaps in.

4. 

Turn over the lower fold of the paper filter (size 1 x 4) and 

place it in the filter funnel. Then fill it with coffee powder.

  NOTE:

Do not put too much coffee powder into the filter to 

avoid spillage.

5.  Now close the lid of the water tank. It must snap into 

place.

6.  Place the lid on the pot. The button on the lid must face 

the handle. Note the recesses on the opening of the pot 

and the latching lugs on the lid. The lid must snap in.

7.  Place the pot onto the storage surface.

  CAUTION: Drip stop

Your appliance comes with a drip stop. It closes when 

removing the coffee pot. This prevents the coffee from 

dripping onto the warming plate if there is still water in 

the filter.

•  Ensure that the lid is attached to the coffee pot. It 

opens the drip stop.

•  If there is still water in the tank, place the pot un-

derneath as soon as possible. Otherwise the filter 

might overflow.

8.  Switch on the appliance. The operating control lamp 

lights up.

  NOTE:

The appliance will switch off automatically a few seconds 

after the brewing process has ended. The operating 

control lamp turns off.

After the Brewing Process

• 

When no more coffee is flowing through the filter you can 

remove the pot. 

•  Press the button on the lid, if you wish to pour coffee 

from the pot.

  NOTE:

The filter holder can be removed from the coffee machine 

by using its handles on the right and left side.

This makes it easier to dispose of the old coffee filter, for 

example.

  WARNING:

If you would like to prepare another pot of coffee right 

away, wait about 5 minutes after the brewing process 

has been completed. Allow the appliance to cool down, 

with its water tank open, to prevent hot splashes of water 

when filling up the water. If the appliance is still too hot, 

a thermostat prevents it from being switched on again 

immediately.

De-scaling

De-scaling is necessary when the brewing time increases 

substantially.
•  Use only commercially available citrus acid-based de-

scaler.

•  Follow the recommended instructions for use.

  WARNING:

•  Afterwards you should boil fresh water in the pot 

three or four times in order to rinse out residues of the 

de-scaling agent.

•  Do not use any coffee powder!

•  Do 

not

 use this water for consumption.