Bosch Tassimo Happy TAS1002N - Инструкция по эксплуатации - Страница 15

11 en

Troubleshooting

The following table contains solutions to problems or faults which may occur  during 

operation of the appliance and that can be easily rectified at home. If you are not 

satisfied with the solutions provided here, please contact our Customer Service 

department. 

Further customer service information can also be found online: 

www.tassimo.com 

www.bosch-home.com 

Problem

Cause

Solution

No LED is lit.

The appliance is in idle mode. Press 

Start / Stop

 button.

The appliance is 

not working and 

none of the display 

elements are 

lighting.

The appliance has no power 

supply.

Check to see whether the appliance is 

connected to the mains.

The brewing starts, 

however there 

is no beverage 

dispensed.

The water tank is not inserted 

correctly.

Check that the water tank is correctly 

inserted. 

The water tank was removed 

during the brewing stage or 

there is air in the system.

Start the cleaning process with the orange 

Service T DISC. Please refer here to the 

section 

First Time Use

, Steps 2 – 14.

The float in the water tank is 

stuck.

Clean the water tank and free the float.

The brewing will 

not start

and/or

the status display 

LED lights up red.

No T DISC inserted.

Check that a T DISC has been inserted.

The appliance does not 

recognise the T DISC bar 

code.

The displays/buttons 

for drink intensity, drink 

temperature and drink size 

are flashing.

Clean the T DISC reading window with a 

soft, damp cloth.

Smooth out the foil of the T DISC with your 

finger so that the bar code can be read.

Use a new T DISC.

If the problem persists, contact the 

 TASSIMO  careline.

The brewing unit is not 

closed properly.

Clean the brewing unit with a soft, damp 

cloth, paying particular attention to the lid 

area.

The appliance was not 

plugged in when the T DISC 

was inserted.

Check that the appliance is plugged into 

the power supply before inserting the 

T DISC.

The brewing unit 

cannot be closed.

The piercing unit and/or the 

T DISC support have not 

been correctly inserted.

Press the piercing unit into its holder using 

both thumbs and check the position of the 

T DISC support.

The T DISC has not been 

correctly inserted.

Replace the damaged T DISC with a new 

one. Place the T DISC with the printed side 

facing downwards so that the tab is resting 

in the intended slot.

The brewing unit is gummed 

up or soiled.

Clean the brewing unit with a soft, damp 

cloth, paying particular attention to the lid 

area.

When closing the brewing 

unit, a slight resistance must 

be overcome.

Press the lid down until it audibly clicks 

into place.