BRAYER BR1121 - Инструкция по эксплуатации - Страница 4

6

7

en

en

• 

Do not leave children unattended to prevent using 

the unit as a toy.

• 

Do not allow children to touch the unit and the power 

cord during the coffee maker operation.

• 

Place the unit out of reach of children during the 

operation and cooling down.

• 

This unit is not intended for usage by physically or 

mentally disabled persons (including children) or

•  by persons lacking experience or knowledge if 

they are not under supervision of a person who 

is responsible for their safety or if they are not 

instructed by this person on the usage of the unit.

•  From time to time check the power cord and the 

power plug integrity.

• 

If the power cord is damaged, it should be replaced 

by the manufacturer, a maintenance service or 

similar qualified personnel to avoid danger.

• 

Do not repair the unit by yourself. Do not 

disassemble the unit by yourself, if any malfunction 

is detected, and after it was dropped, unplug the unit 

and apply to the service center.

•  Transport the coffee maker in the original package.

• 

Keep the unit out of reach of children and disabled 

persons.

COFFEE MAKER IS INTENDED FOR HOUSEHOLD 

USE ONLY, DO NOT USE THE COFFEE MAKER FOR 

COMMERCIAL OR LABORATORY PURPOSES.

BEFORE USING THE COFFEE MAKER

After unit transportation or storage at low 

temperature, it is necessary to keep it for at least 

three hours at room temperature.

•  Unpack the coffee maker and remove all the 

packaging materials. 

•  Keep the original package.

•  Check the delivery set.

• 

Read the safety measures and operating 

recommendations.

•  Examine the coffee maker for damages, in case of 

damage do not plug it into the mains.

•  Make sure that the specifications of power supply 

voltage specified on the lower panel of the unit 

correspond to the specifications of your mains. When 

the unit is used in the mains with 60 Hz frequency, it 

does not need any additional settings.

•  Wipe the surface of the coffee maker body with a 

clean, slightly damp cloth to remove dust. 

•  Take the handle and turn the funnel to the left.

•  Remove the filter holder (4) from the funnel, remove 

the reusable filter (5).

• 

Wash all removable parts in warm water with a 

neutral detergent: the coffee flask (1), the filter holder 

(4), the filter (5), rinse them and dry.

•  Install the filter holder (4) into the funnel.

•  Insert the filter (5) into the holder (4).

• 

Turn the funnel to the right until bumping.

•  Fill about one half of the coffee flask (1) with pure 

water.

•  Open the lid (6) and pour the water from the flask (1) 

to the water tank (7).

•  Close the lid (6) and put the flask (1) on the tray (10).

•  Insert the plug into the mains socket, the digital 

symbols ”12:00” will appear on the display (16).

•  Switch the coffee maker on by pressing the on/off 

button (19) «ON/OFF», the light indicator (18) will 

light up.

•  After the water tank (7) becomes empty, switch the 

coffee maker off by pressing the on/off button (19) 

«ON/OFF» again, the light indicator (18) will go out.

• 

Note:

 if necessary, you can switch the coffee maker 

off at any moment by pressing the on/off button (19) 

«ON/OFF». 

• 

Let the unit cool down for 5 minutes and pour the 

water out from the flask (1). 

• 

If necessary, repeat the washing cycle of the coffee 

maker 2-3 times.

MAKING COFFEE

• 

Ready coffee is made by single passing of hot water 

through the layer of ground coffee in the filter (5). 

The taste of the drink depends on the quality of raw 

products, therefore we recommend using well-

roasted and fresh-ground coffee beans.

•  Take the handle and turn the funnel to the left.

• 

Measure the required amount of ground coffee and 

put it into the filter (5). 6 grams of ground coffee per 

one coffee cup is required on average; adjust the 

quantity according to your taste.

• 

Turn the funnel to the right until bumping.

•  Open the lid (6), fill the tank (7) with cold water up to 

the required level. Determine the water level using 

the scale (8).

• 

Close the lid (6).

•  Put the flask (1) on the tray (10).

•  Insert the plug into the mains socket, the digital 

symbols ”12:00” will appear on the display (16).

•  Switch the coffee maker on by pressing the on/off 

button (19) «ON/OFF», the light indicator (18) will 

light up.

•  After the flask (1) is filled with ready coffee, switch 

the coffee maker off by pressing the on/off button 

(19) «ON/OFF» again, the light indicator (18) will go 

out.

•  To keep the coffee hot, leave the flask (1) on the tray 

(10) and do not switch the coffee maker off.

• 

Notes: 

 -

during coffee making the buttons «PROG», 

«HOUR» and «MIN» are disabled.

 -

the keep warm time for ready coffee is limited to 

40 minutes, after that the coffee maker will switch 

off.