Einhell PXC TE-CG 18 - Инструкция по эксплуатации - Страница 17

GB

- 17 -

• 

 Fit the rubber cap back on the nozzle

6. Operation

6.1 Operation (Fig. 6)

• 

Check that a glue stick is fitted (see point 5.2)

• 

Press the On/Off switch (1) briefly.

• 

The LED (2) will light up red to indicate that 

the equipment is heating up

• 

This takes approx. 120 seconds, after which 

the LED (2) will light up green.

• 

The equipment is now ready for operation.

• 

To switch the equipment off again, press the 

ON/OFF briefly just the once

Warning!

Never set the equipment down once you have 

started using it.

If or when your gluing work is interrupted or 

fi

 ni-

shed, always be sure to stand the equipment on 

its rechargeable battery as shown in Fig. 4.

Switch the equipment o

ff

  and allow it to cool down 

completely before you pack it away.

6.2 Working with the cordless hot glue gun

• 

You can now apply the glue by pressing the 

trigger lever (4) after the heating up time

• 

Press both surfaces together immediately 

and apply pressure to them

• 

It takes about 30 seconds for the glue to set

• 

Always stand the cordless hot glue gun on its 

rechargeable battery (Fig. 4).

The equipment switches o

ff

  automatically after 

approx. 5 minutes of non-use.

Important!

Glue stains on textiles cannot be removed.

6.3 LED light (Fig. 1/Item 8)

The LED light (8) will come on automatically as 

soon as the equipment is switched on.

To switch o

ff

  the LED light, press the On/O

ff

switch (1) for about 3 seconds when the equip-

ment is switched on. To switch the LED light on 

again, repeat the procedure.

6.4 Battery capacity indicator (Fig. 7/Item e)

Press the button for the battery capacity indicator 

(d). The battery capacity indicator (e) will indicate 

the charge status of the battery by means of 3 

LEDs.

All 3 LEDs are lit:

The battery is fully charged.

2 or 1 LED(s) are lit:

The battery has an adequate remaining charge.

1 LED blinks:

The battery is empty, recharge the battery.

All LEDs blink:

The battery pack has undergone exhaustive di-

scharge and is defective. Do not use or charge a 

defective battery pack.

7.  Cleaning, maintenance and 

ordering of spare parts

Warning!

Allow the equipment to cool down before you start 

to clean it.

7.1 Cleaning

• 

 Keep all safety devices, air vents and the 

motor housing free of dirt and dust as far as 

possible. Wipe the equipment with a clean 

cloth or blow it with compressed air at low 

pressure.

• 

 We recommend that you clean the device  

immediately each time you have finished 

using it.

• 

 Clean the equipment regularly with a moist 

cloth and some soft soap. Do not use 

cleaning agents  or solvents; these could at-

tack the plastic parts of the equipment. Ensu-

re that no water can seep into the device. The 

ingress of water into an electric tool increases 

the risk of an electric shock.

7.2 Maintenance

There are no parts inside the equipment which  

require additional maintenance.

Anl_TE_CG_18_Li_Solo_SPK9.indb   17

Anl_TE_CG_18_Li_Solo_SPK9.indb   17

03.05.2019   10:28:01

03.05.2019   10:28:01