Einhell PXC TE-CG 18 - Инструкция по эксплуатации - Страница 16

GB

- 16 -

• 

Cordless Hot Glue Gun

• 

Original operating instructions

• 

 Safety  instructions 

3. Proper use

You can use the cordless hot glue gun to glue the 

following materials: Wood, plastics, textiles, card-

board, ceramics, leather, etc.

The equipment is to be used only for its prescri-

bed purpose. Any other use is deemed to be a 

case of misuse. The user / operator and not the 

manufacturer will be liable for any damage or inju-

ries of any kind caused as a result of this.

Please note that our equipment has not been de-

signed for use in commercial, trade or industrial 

applications. Our warranty will be voided if the 

machine is used in commercial, trade or industrial 

businesses or for equivalent purposes.

4. Technical data

Power supply:  ......................................... 18 V DC
Heating time:  .................................  approx. 120 s
Melting temperature:  ................................  170°C
Glue stick diameter:  ................................. 11 mm
Weight:  .....................................................0.25 kg

Caution!

Residual risks

Even if you use this electric power tool in 

accordance with instructions, certain resi-

dual risks cannot be rules out. The following 

hazards may arise in connection with the 

equipment’s construction and layout:

1.   Lung damage if no suitable protective dust 

mask is used.

5.  Before starting the equipment

Danger!

Charge the equipment only with the charger sup-

plied.

Only place the equipment on non-

fl

 ammable 

surfaces.

5.1 Charging the Li battery pack (Fig. 2-3)

1.  Remove the battery pack (5) from the handle, 

pressing the pushlock button (6) downwards 

to do so.

2.  Check that your mains voltage is the same as 

that marked on the rating plate of the battery 

charger. Insert the power plug of the charger 

(7) into the socket outlet. The green LED will 

then begin to 

fl

 ash.

3.  Push the battery pack onto the battery char-

ger. 

In section 10 (Charger indicator) you will 

fi

 nd a 

table with an explanation of the LED indicator on 

the charger.

If the battery pack fails to charge, check for the 

following:

• 

 voltage at the power socket

• 

 whether there is good contact at the charging 

contacts of the charging unit

If the battery pack still fails to charge, send

• 

 the charger and charging adapter

• 

 and the battery pack

to our customer service center.

5.2 Inserting the glue stick (Fig. 4)

Push the glue stick (a) into the opening (b) as far 

as the stop.

Important!

To avoid causing damage to the inside of the 

equipment, do not pull the glue stick out of the 

equipment again after it has has melted.

5.3 Changing the nozzles (Fig. 5)

To be able to work more e

ff

 ectively in certain po-

sition, you can change the nozzles (3). Proceed 

as follows:

• 

 Pull the rubber cap (c) off the nozzle (3)

• 

 Remove the nozzle using a 13 mm hex key

• 

 Check the seal (rubber ring) on the new nozz-

le for damage

• 

 Fit the new nozzle to the equipment and tigh-

ten it

Anl_TE_CG_18_Li_Solo_SPK9.indb   16

Anl_TE_CG_18_Li_Solo_SPK9.indb   16

03.05.2019   10:28:01

03.05.2019   10:28:01