Instrumax SNIPER 80 - Инструкция по эксплуатации - Страница 5

5

SNIPER 80 

     PLUS

Press button (6) to set the reference from the front, rear, tri-

pod. When the end-piece is folded out fully, the reference rear 

is set.

You will see the reference symbol on the display.

Selecting Units

Press and hold the button (5) for 2 sec. until the desired unit 

is displayed.

Illumination

Press and hold the button (6) for 2 seconds to switch the illu-

mination on or off.

Clear-Key

Cancel the last action. Press button (7).

MEASUREMENTS

Single distance measurement

Press button and hold button  ON (1) to activate the laser. Press 

again to trigger the distance measurement. A beep will sound. 

The result is displayed immediately.

Continuous Measurement

Press and hold button ON (1) for about 2 seconds to start 

continuous measuring. That function allows to measure mini-

mum and maximum distances from the fixed point. This func

-

tion is widely used for diagonal measurements (maximum 

value) or horizontal distances up to vertical plane (minimum 

value). Minimum (5) and maximum (3) values will be shown 

on the display. 

FUNCTIONS

Area

Press the button (2) once.The symbol Area (4) is displayed.

Press button ON (1) to take the first measurement (for exam

-

ple, length). Measured value is displayed in line 3.

Press button ON (1) to take the second measurement (for ex-

ample, width). The result of measured area is displayed in the 

line 2. The area result is displaye din the main line. Perimeter