Condtrol Xliner Duo 360 - Инструкция по эксплуатации - Страница 8

14

15

user manual

C R O S S 

L I N E  L A S E R

EN

user manual

C R O S S 

L I N E  L A S E R

EN

XLiner Duo/Combo 360

XLiner Duo/Combo 360

CARE AND MAINTENANCE

Maintenance of the following recommendations will extend the life 
of the device:

- Transpor t and carr y the product only with locked compensator.
- Keep the product clean and protected from any bumps, dust and 
dampness; do not allow getting moisture, dust or other dir t inside of 
the product.
- In case if any moisture goes into the product, remove the batteries 
and take it to the ser vice center.
- Do not keep or use the device for a long time at high humidity 
conditions.
- Keep the instrument clean and wipe it with a clean and sof t cloth.

Mishandling of the following rules can cause electrolite leakage 
from the batteries or other damages:

- Remove the batteries from the product if you do not use it for a long 
time.
- Do not use dif ferent batter y types with dif ferent charge levels.
- Do not leave discharged batteries in the product.

Check of vertical line

Use a plumb bob as a reference of a vertical line. Place the laser level at 
a 1,5m distance from the plumb bob (see Fig. E).

1. Move compensator lock to 

ON

 position        , then switch on vertical 

plane and align vertical laser line with the low point of plumb bob. 

2. If deviation between the laser line and the plumb line exceeds 0.2 
mm per 1m of the plumb bob length (for a 2.5m plumb bob deviation 
shouldn’t exceed 0.5 mm) please contact service center.

E