ADA Cube Professional Edition - Инструкция по эксплуатации - Страница 5

5

point of cross laser line is marked B.

Please note the distance of B to A 

should be 5m. Measure the distance between M to cross laser lune, if the 

difference is over 3mm, the laser is out of calibration, please contact with 

seller to calibrate the laser.

TO CHECK PLUMB

Choose a wall and set laser 5m away from the wall. Mark point A on the 
wall, please note the distance from point A to ground should be 3m. Hang 

a plumb line from A point to ground and find a plumb point B on ground. 

turn on the laser and make the vertical laser line meet the point B, along 
the vertical laser line on the wall and measure the distance 3m from point 
B to another point C. Point C must be on the vertical laser line, it means the 
height of C point is 3m.
Measure the distance from point A to point C, if the distance is over 2 mm, 
please, contact with seller to calibrate the laser.

CARE AND CLEANING

Please handle line laser  with care. Clean with soft cloth only after any use. 
If necessary damp cloth with some water. If instrument is wet clean and 
dry it carefully. Pack it up only if it is perfectly dry. Transport in original 
container/case only.

Note:  During  transport  On/Off  compensator  lock  (5)  must  be  set  to  posi

-

tion “OFF”. Disregard may lead to damage of compensator.

SPECIFIC  REASONS FOR ERRONEOUS MEASURING RESULTS

•   Measurements through glass or plastic windows;
•   Dirty laser emitting window;
•   After line laser has been dropped or hit. Please check the accuracy;

•   Large fluctuation of temperature: if instrument will beused in cold areas 

after it has been stored in warm areas (or the other way round) please wait 
some minutes before carrying out measurements.

English