ADA Cube Professional Edition - Инструкция по эксплуатации - Страница 4

4

English

CHANGE OF BATTERIES

Open battery compartment. Insert batteries. Take care to correct polarity. 
Close battery compartment. ATTENTION: If you are not going to use instru-
ment for a long time, take out batteries.

OPERATION

Place the line laser on the working surface or mount it on the tripod/pil-
lar or wall mount (comes with the instrument). Switch on the line laser : 
turn the compensator switch (3) to the position “ON”. When enabled, the 
vertical and horizontal plane projected constantly. Visual alarm (blinking 
line) and audible signal indicate that the device was not installed within the 
compensation range ± 3 º. To properly work align the unit in a horizontal 
plane.

         TO CHECK THE ACCURACY OF LINE LASER (SLOPE OF PLANE)

Set up the line laser  between two walls, the distance is 5 m.Turn on the 
Line Laser and mark the point of cross laser line on the wall. Set up the 
instrument 0,5-0,7m away from the wall and make, as described above, the 

same masrks. If the difference {a1-b2} and {b1-b2} is less then the value of 
“accuracy” (see spesifications), there is no need in calibration. 
Example:  when  you  check  the  accuracy  of  Line  Laser  the  difference  is 
{a1-a2}=5  mm  and  {b1-b2}=7  mm.  The    instrument’s  error:  {b1-b2}-
{a1-a2}=7-5=2 mm. Now you can compare this error with standard error.
If  the  accuracy  of  Line  Laser  isn’t  corresponding  with  claimed  accuracy, 

contact the authorized service center.

        TO CHECK THE ACCURACY OF HORIZONTAL BEAM

Choose a wall and set laser 5M away from the wall. Turn on the laser and 
cross laser line is marked A on the wall. Find another point M on the hori-
zontal line, the distance is around 2.5m. Swivel the laser, and another cross 

3

4