Измерительные приборы ADA Cube 360 Professional Edition - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
4
English
CHANGE OF BATTERIES
Open battery compartment. Insert batteries. Take care to correct polarity.
Close battery compartment. ATTENTION: If you are not going to use instru-
ment for a long time, take out batteries.
OPERATION
Cube 360 is a reliable and convenient line laser. It will be irreplaceable
tool for many years. Before use, remove battery compartment cover. In-
sert three batteries into battery compartment with proper polarity, then
put the cover back. Set the compensator locking grip (5) into ON position,
two laser beams will be on. If the switch is ON,that means the power is on
and the compensator is working. Visual alarm (blinking line) and audible
signal indicate that the device was not installed within the compensation
range ± 4 º. To properly work align the unit in a horizontal plane. If the
switch (5) is in intermediate position, that means the power is opened,the
compensation is still locked, but it will not warn if you issue the slope. It’s
the hand-mode. If the switch (5) is OFF, that means that the line laser is
off, the compensator is also locked. Press button (1) only once- horizontal
beam will turn on. Press the button (1) one more time - vertical laser beam
will turn on. Again press the button (1) - horizontal and vertical beams will
turn on. Press button (2) once. Otdoor mode is activated. Press button (2)
one more time. The line laser begins to work in indoor mode.
TO CHECK THE ACCURACY OF LINE LASER (SLOPE OF PLANE)
Place line laser on the tripod 5m away from the wall so the horizontal laser
line will be directed to the wall. Switch on the power. The line laser starts
to self-level. Mark point A on the wall to show the contact of laser beam
with the wall. Turn the line laser by 90° and mark points В, С, D on the wall.
Measure distance “h” between the highest and lowest points (these are A
and D points in the picture). If “h”is ≤ 6 mm, the line laser accuracy is good.
If “h” exceeds 6 mm, apply service center.
3
Характеристики
Остались вопросы?Не нашли свой ответ в руководстве или возникли другие проблемы? Задайте свой вопрос в форме ниже с подробным описанием вашей ситуации, чтобы другие люди и специалисты смогли дать на него ответ. Если вы знаете как решить проблему другого человека, пожалуйста, подскажите ему :)
