ADA 6D Servoliner - Инструкция по эксплуатации - Страница 7

7

English

         MANUAL MODE

1. Switch the line laser ON. Auto leveling function is activated. Press but-
ton (6) to switch on the  auto manual mode. LED indicator (7) will be ON 
constantly.

2. It is possible to set the inclination of the laser beams along the axis
X and Y in the range of ±3º. 

3. Press and hold button H (1) or V(3)  to set the tilt angle along the axis X.
 
4. Press button (3) to set the tilt angle along the axis Y. Press and hold but-
ton H (1) or V (3)  to set the tilt angle along the axis Y.

5. Laser lines begin to flash when reaching the full distance position. Press 
button  (6)  to  exit  from  the  full  tilt  distance  position  or  switch  off  the  tilt 

mode.

           TO CHECK THE ACCURACY OF LINE LASER
           (SLOPE PLANE)

Set up the line laser between two walls, the distance is 5 m.Turn 
on the Line Laser and mark the point of cross laser line on the wall. 
Set up the line laser 0,5-0,7m away from the wall and make, as described 

above, the same masrks. If the difference {a1-b2} and {b1-b2} is less then 
the value of “accuracy” (see spesifications), there is no need in calibration.

Example

:  when  you  check  the  accuracy  of  Line  Laser  the  difference 

is  {a1-a2}=5  mm  and  {b1-b2}=7  mm.  The  instrument’s  error:  {b1-b2}-
{a1-a2}=7-5=2 mm. Now you can compare this error with standard error.

If the accuracy of Line Laser isn’t corresponding with  claimed accuracy, 
contact the authorized service center.

5

4