ADA 6D Servoliner - Инструкция по эксплуатации - Страница 5

5

English

OPERATION

1. 

Li-battery or battery adapter AA can be used for operation with line 
laser. If using a battery adapter AA, install batteries in it. Open the 
battery compartment cover. Insert the batteries into the battery 
adapter. Close the battery compartment cover. Install Li-battery / 
battery adapter AA (11) on the housing of the line laser. To replace 
the Li-battery / battery adapter press clip (10) and release it from the 
housing of the line laser.  

2. 

To check the power level of the Li-battery use power indicator (9). 
To do this, press the button with the battery icon. The number of 
highlighted segments on the indicator shows the power level.  It is 
possible to use charger to operate with the tool. Use charger for 
rechargeable batteries. Connect the charger to the connector for 
power switch (13) that is located on the housing of the line laser. Line 
laser will be ON and charge rechargeable batteries.         

WARNING: Never use charger for ordinary batteries. Do not leave 

the line laser unattended while using charger. Parameters of 
the charger must correspond to the parameters of domestic 
electricity. Output voltage must be no more than 12V.

          KEYPAD

1. 

Horizontal switch (H)          

2. 

Power switch On/Off  (Power LED)                                                                                                

3. 

Vertical switch (V)

4. 

Detector LED

5. 

Detector mode

6. 

Self-leveling mode

7. 

Self-leveling off LED

3