Smeg FAB32LON1 - Инструкция по эксплуатации - Страница 19

Cleaning and maintenance

43

EN

4.4 Replacing the lamp

1. Remove the bulb cover using a tool (e.g. 

a screwdriver).

2. Unscrew and remove the lamp.

3. Replace the lamp with one of the same 

type.

4. Refit the cover: line up the teeth of the 

cover with the slots in the back of the 
lamp housing, then close the cover.

4.5 What to do if...

The appliance does not work:
•  Make sure that the appliance is plugged 

in and that the main switch is turned on.

The compressor starts to function too often 
or functions continuously:
•  The room temperature is too high.
•  The door is being opened too often or 

for too long.

•  The door is not closing/sealing properly.
•  The freezer is loaded with too many 

fresh foods.

•  Check that sufficient air can circulate 

around the sensor on the right-hand side 
of the refrigerator compartment.

•  Check that the back of the freezer is 

properly ventilated and that the 
condenser is not too dirty.

Excessive ice or condensation has built up 
inside the refrigerator compartment:
•  The door is being opened too often or 

for too long. 

•  Hot foods have been placed inside the 

refrigerator compartment.

•  The foodstuffs or containers are in 

contact with the rear wall.

•  The door seal is damaged or dirty. 

Clean or replace it.

Water is forming inside the refrigerator 
compartment:
•  The drainage channel or opening is 

blocked.