Kuppersberg VBMR 134 - Инструкция по эксплуатации - Страница 26

26

TECHNICAL PASSPORT

ENGLISH

Built under larder

pluging in 5 – 10 minutes after power is re-

stored.

Â

If you unplug the refrigerator for any 

reason you should wait at least 5 min to re-

plug. This will avoid damage to the refrig-

erator’s components.

Â

The cooling unit of your refrigerator 

is hidden at the rear of the appliance. There-

fore, water droplets or icing may form on the 

rear surface of your fridge due to the opera-

tion of the compressor at specified intervals. 

This is normal, there is no need to perform a 

defrosting operation unless the icing is ex-

cessive.

Â

If you do not intend to use your 

fridge for a long time (e.g. in summer holi-

days),  turn  the  thermostat  to  the  «•»  posi

-

tion. After defrosting, clean your fridge and 

leave the door open to prevent humidity and 

smells.

Â

If the problem persists after you 

have followed all the instructions above, 

please consult to the nearest Authorised 

Service Centre.

Â

The appliance you have purchased is 

designed for domestic use and can only be 

used at home and for the stated purposes. It 

is not suitable for commercial or common 

use. If the consumer uses the appliance in 

a way that does not comply with this, we 

emphasise that the manufacturer and the 

dealer will not be responsible for any repair 

and failure within the guarantee period.

Tips for saving energy

1.Install the appliance in a cool, well 

ventilated room , but not in direct sunlight 

and not near a heat source (radiator, cooker. . 

etc). Otherwise use an insulating plate.

2.Allow warm food and drinks to cool 

down outside the appliance.

3.Cover drinks or other liquids when 

placing them in the appliance Otherwise 

humidity increases in the appliance. 

Therefore, the working time gets longer. 

Also covering drinks and other liquids helps 

to preserve smell and taste.

4.Try to avoid keeping the doors open 

for long periods or opening the doors too 

frequently as warm air will enter the cabinet 

and cause the compressor to switch on 

unnecessarily often.

5.Keep the covers of the different 

temperature compartments (crisper, chiller 

. . .etc ) closed 

6.Door gasket must be clean and pliable. 

Replace gaskets if worn.

Please note! 

The following shall not be considered as 

defects of the Product

Refrigerat

ors

Discoloration of product 

materials when using the 

product

Noise of flowing coolant during 

compressor operation
Minor technical smells of plastic 

coming from a new product 
Blushing of plastic and aging of 

rubber elements of the product 

over time