Kuppersberg NSFT195902W - Инструкция по эксплуатации - Страница 14

14

TEchnical passporT

English

refrigerator  nsFT 195902

Problem

Possible cause & Solution

A layer of frost 

occurs in the 

compartment

Check that the air outlets are not blocked by food and 

ensure food is placed within the appliance to allow 

sufficient ventilation. Ensure that door is fully closed. To 

remove the frost, please refer to cleaning and care chapter.

Temperature inside 

is too warm

You may have left the doors open too long or too 

frequently; or the doors are kept open by some obstacle; or 

the appliance is located with insufficient clearance at the 

sides, back and top

Temperature inside 

is too cold

Increase the temperature by following the "Display 

controls” chapter.

Doors cant be 

closed easily

Check whether the top of the refrigerator is tilted back by

10-15mm to allow the doors to self close, or if something 

inside is preventing the doors from closing.

Water drips on the 

floor

The water pan (located at the rear bottom of the cabinet) 

may not be properly leveled, or the draining spout (located 

underneath the top of the compressor depot) may not 

be properly positioned to direct water into this pan, or 

the water spout is blocked. You may need to pull the 

refrigerator away from the wall to check the pan and spout.

The light is not 

working

•The LED light may be damaged. Refer to replace LED 

lights in cleaning and care chapter.

•The control system has disabled the lights due to the door 

being kept open too long, close and reopens the door to 

reactivate the lights.

FAULT DISPLAY

Fault display shows as following under Fault mode:

ERROR CODE

ERROR TYPE

UC

Communication failure or model mismatch

RS

Sensor failure (refrigerating chamber)

ES

Failure of ambient temperature sensor

FS

Sensor failure (freezing chamber)

Fd

Defrosting sensor failure

FF

Fan failure

FH

Defrosting failure