Korting KNF 1857 X - Инструкция по эксплуатации - Страница 25

EN - 25 -

Installation warnings

Before using your fridge for the first time, please pay attention to the following points:

• 

The operating voltage for your fridge is 220-240 V at 50Hz.

• 

The plug must be accessible after installation.

•  Your fridge may have an odour when it is operated for the first time. This is normal and 

the odour will fade when your fridge starts to cool. 

• 

Before connecting your fridge, ensure that the information on the data plate (voltage 

and connected load) matches that of the mains electricity supply. If in doubt, consult a 

qualified electrician.

•  Insert  the  plug  into  a  socket  with  an  efficient  ground  connection.  If  the  socket  has  no 

ground  contact  or  the  plug  does  not  match,  we  recommend  you  consult  a  qualified 

electrician for assistance.

• 

The appliance must be connected with a properly installed fused socket. The power 

supply (AC) and voltage at the operating point must match with the details on the name 

plate of the appliance (the name plate is located on the inside left of the 

appliance).

• 

We do not accept responsibility for any damages that occur due to 

ungrounded usage.

•  Place your fridge where it will not be exposed to direct sunlight.
•  Your fridge must never be used outdoors or exposed to rain.
• 

Your appliance must be at least 50 cm away from stoves, gas ovens and 

heater cores, and at least 5 cm away from electrical ovens.

•  If your fridge is placed next to a deep freezer, there must be at least 2 cm between them 

to prevent humidity forming on the outer surface.

•  Do not cover the body or top of fridge with lace. This will affect the performance of your 

fridge.

• 

Clearance of at least 150 mm is required at the top of your appliance. Do not place 

anything on top of your appliance.

• 

Do not place heavy items on the appliance.

• 

Clean the appliance thoroughly before use (see Cleaning and Maintenance).

• 

Before using your fridge, wipe all parts with a solution of warm water and a teaspoon of 

sodium bicarbonate. Then, rinse with clean water and dry. Return all parts to the fridge 

after cleaning.

• 

Use the adjustable front legs to make sure your appliance is level and stable. You can 

adjust the legs by turning them in either direction. This must be done before placing food 

in the appliance.

• 

Install the two plastic distance guides (the parts on the black vanes -condenser- at the 

rear) by turning it 90° (as shown in the figure) to prevent the condenser 

from touching the wall.

•  The distance between the appliance and back wall must be a maximum 

of 75 mm.