Jacky`s JR FV20B1 - Инструкция по эксплуатации - Страница 40

EN 

40

BEFORE USING THE APPLIANCE

Installing and operating your fridge

Before using your fridge, you should pay attention to the 

following points:

CAUTION!

 Never replace any electrical parts inside the 

refrigerator. In cases requiring replacement, contact 

Authorised Technical Service.

• 

The operating voltage for your fridge is 220-240 V at 50Hz.

• 

Do not use plug adapter.

• 

We do not accept responsibility for any damages that 

occur due to ungrounded usage.

• 

Place your fridge where it will not be exposed to direct 

sunlight.

• 

Your appliance should be at least 50 cm away from stoves, 

gas ovens and heater cores, and at least 5 cm away from 

electrical ovens.

• 

Your fridge should never be used outdoors or exposed to 

rain.

• 

When your fridge is placed next to a deep freezer, there 

should be at least 2 cm between them to prevent humidity 

forming on the outer surface.

• 

Do not place heavy items on the appliance.

• 

Do not place anything on your fridge, and install your fridge 

in a suitable place so that at least 15 cm of free space is 

available above it.

• 

Use the adjustable front legs to make sure your appliance 

is level and stable. You can adjust the legs by turning them 

in either direction. This should be done before placing food 

in the fridge.

• 

Before using your fridge, wipe all parts with a solution of 

warm water and a teaspoon of sodium bicarbonate, then 

rinse with clean water and dry. Place all parts in the fridge 

after cleaning.

• 

Install the plastic distance guide (the part with black vanes 

at  the  rear)  by  turning  it  90°  (as  shown  in  the  figure)  to 

prevent the condenser from touching the wall.

• 

The refrigerator should be placed against a wall with a free 

space not exceeding 75 mm.