Fulgor Milano FFSI 351 NF ED X - Инструкция по эксплуатации - Страница 24

1169

24

Cleaning - Troubleshooting

EN

Green and 

Yellow to Earth

Blue to

Neutral

13 amp Fuse

Brown

to Live

Cord Clamp

R

V

CLEANING

Before starting any cleaning, disconnect the 

appliance from the mains electricity supply.

The protections (wire grill, covers) must not be 

removed by unqualified personnel: do not use the 

appliance if the protections have been removed.

WHEN CLEANING THE INTERNAL PLASTIC PARTS AND 

THE DOOR GASKET:

do not use abrasives or detergents of any kind.

-  Use a warm solution of bicarbonate of soda (two 

spoonfuls in two litres of water).

CLEANING THE CONDENSER
-  This should be carried out at least twice a year.
-  Clean using a domestic vacuum cleaner or a brush. 

A dirty condenser will have a negative effect on the 

appliance and reduce its performance.

FOR PROLONGED ABSENCES
-  if the appliance is to be left unused for a long period 

of time, e.g. holidays, it must be unplugged, emptied, 

cleaned and dried. The door must be left open to 

prevent the formation of bad smells.

CLEANING THE WATER DRAIN

When cleaning the condenser, check that the rear drain 

pipe R is not blocked.

-  Remove drain pipe R from the container V and if 

necessary clean it.

POWER SUPPLY CABLE

-  Periodically inspect the power cable to check its 

condition.

-  If the cable is damaged, do not use the appliance and 

do not attempt any repairs. Call a qualified technician 

to replace the faulty cable.

ELECTRICAL CONNECTION

Check that the mains voltage complies with that indicated on 

the rating plate located on the bottom left of the compartment. 

If the mains socket does not have an earth connection or if 

the plug is not suitable for the mains supply system, refer to 

a qualified electrician. Do not use adapters or extension leads, 

as these may overheat and burn.
WARNING: THIS APPLIANCE MUST BE EARTHED

If the appliance has been fitted with a non-rewirable plug of 

the incorrect type for the mains socket, cut off the plug and fit 

a new one. The removed plug must be thrown away. Inserting 

an unsuitable plug into a 13 Amp socket is likely to cause an 

electrical hazard. When a non rewirable plug or rewirable 13 

Amp (BS1363) plug is used, it must be fitted with a 15 Amp 

A.S.T.A. approved (BS1362) fuse. If any other type of plug is 

used it must be wired as follows. Connect the GREEN & YEL-

LOW wire to the earth terminal marked with the letter “E” or 

earth symbol,   or coloured green or green & yellow. Connect 

the  BLUE  wire to the neutral terminal marked with the letter 

“N” or coloured black. Connect the BROWN coloured wire to 

the live terminal marked with the letter “L” or coloured red.