Fulgor Milano FFSI 351 NF ED X - Инструкция по эксплуатации - Страница 19

1169

19

Using the appliance

EN

CONTROL PANEL 

1 ON/OFF 

2  TEMPERATURE ADJUSTMENT 

       UP 

       DOWN 

3  DISPLAY SCREEN 

4  DOOR OPEN ALARM ON DISPLAY 

5  SUPER FUNCTION 

6  ALARM TEMPERATURE FUNCTION

IMPORTANT WARNING

Whenever the product has been lying horizontally during 
transportation, it should be left to stand upright for at 
least six hours before it is switched on, otherwise it may 
be noisy when it is in operation.

NOTE: Before inserting the plug into the electri-

cal socket, ensure that the line voltage corresponds 
with that indicated in the product data plate. Connect 
the socket to the mains. Do not use adapters or 
extension leads, as these may overheat and burn.

SWITCHING ON THE APPLIANCE 

Open the door. The refrigerator start by pressing the 

1 ON/OFF button for at least 0.5 seconds, followed 

by an acoustic signal (1 BEEP): the display shows the 

temperature set in the freezer compartment and flashes 

for 6 seconds, then the actual temperature of the com-

partment appears. The display shows a temperature 

range between +20 and -40°C. If a temperature higher 

than +20°C is detected, the display (3

) will show the “

H

” 

symbol (steady light). After 30 seconds the appli ance starts 
operating. The appliance shutdown occurs by pressing the 

1 ON/OFF

 button for at least 5 seconds, followed by an 

acoustic signal (

2 BEEP). At this point the display is off.

Horizontal dashes are displayed with the appliance 

switched off on the display (3)

.

SETTING THE TEMPERATURE 

The appliance has a standard setting suitable for normal 

mode operation. 

The temperature can be set between -14 °C and -24 

°C. The temperature is set by pressing the 2 UP/DOWN 

symbols, UP for higher values and DOWN for lower va-

lues. Upon starting the appliance, the display (3) shows 

the actual temperature; it varies one degree at a time 

whenever the 2 UP/DOWN symbols are slightly pressed; 

during temperature setting, the displayed value flashes. 

About 5 seconds after the last symbol has been pressed, 

the actual temperature is displayed. The temperature 

slowly reaches the set value.

   ATTENTION! If the appliance is switched on 

immediately after it has been switched off, the 

compressor will start after 10 minutes. This is part 

of the appliance normal operation.

NO-FROST

Technology