Холодильник Gorenje RC4180AW - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
Instructions for Use
11
•
Slip the upper door onto the plug functioning
as the upper plug.
•
Turn the middle hinge by 180° and attach it
on the opposite side of the appliance.
•
Slip the lower door onto the middle hinge.
•
Screw in the lower footed hinge to the
opposite side.
•
Unscrew the handles and replace them to
the opposite side (not for handles mouinted
horizontally). Some screws are covered with
caps. Take them off before undoing the
screws.
•
Plug the remaining holes with decorative
caps.
•
Check the gasket, it shouldn't be creased
and it should seal well. In case it does not fit
perfectly, pull it out and rotate for 180°.
•
Should the seal not adhere to the casing of
the appliance perfectly, it will have to be
heated from a suitable distance (by means
of hair drier, for example) and lightly
stretched to the required height. In certain
models it is not possible to replace the door
gasket.
1
Plug (upper hinge)
2
Door plug
3
Middle hinge
4
Washer
5
Lower hinge with foot
6
Washer
7
Foot
8
Handle
9
Door hinge
Maintenance and Cleaning
Automatic Defrosting of the
Refrigerator
There is no need to defrost the refrigerator,
because ice depositing on the inner back wall
is defrosted automatically.
Ice is depositing on the inner back wall during
the compressor operation; later on, when the
compressor is not operating ice is defrosting
and water drops collect and drain through the
outlet in the inner back wall into the drain pan
situated above the compressor, from where it
evaporates.
Manual Defrosting of the Freezer
When the frost and ice layer in the freezer is
3-5 mm thick, you should clean the freezer.
•
Few hours before defrosting set the
thermostat to position
7
, so that packages
are well frozen. Reset the thermostat to
STOP (0)
position and disconnect the power
supply. Empty the freezer and take care that
the packages remain frozen.
•
Insert the enclosed pipe into the groove in
the bottom of the appliance and place a
vessel underneath to collect the defrost
water. Defrosting is accelerated if the door is
left open.
