AEG S86340KG1 - Инструкция по эксплуатации - Страница 5

• Unpack the appliance and check if there are damages on it. Do not connect the appliance

if it is damaged. Report possible damages immediately to the place you bought it. In that

case retain packing.

• It is advisable to wait at least four hours before connecting the appliance to allow the

oil to flow back in the compressor.

• Adequate air circulation should be around the appliance, lacking this leads to overheat

-

ing. To achieve sufficient ventilation follow the instructions relevant to installation.

• Wherever possible the back of the product should be against a wall to avoid touching

or catching warm parts (compressor, condenser) to prevent possible burn.

• The appliance must not be located close to radiators or cookers.

• Make sure that the mains plug is accessible after the installation of the appliance.

• Connect to potable water supply only.

3)

Service

• Any electrical work required to do the servicing of the appliance should be carried out

by a qualified electrician or competent person.

• This product must be serviced by an authorized Service Centre, and only genuine spare

parts must be used.

Environment Protection

This appliance does not contain gasses which could damage the ozone layer, in either its

refrigerant circuit or insulation materials. The appliance shall not be discarded together

with the urban refuse and rubbish. The insulation foam contains flammable gases: the

appliance shall be disposed according to the applicable regulations to obtain from your

local authorities. Avoid damaging the cooling unit, especially at the rear near the heat

exchanger. The materials used on this appliance marked by the symbol   are recyclable.

Control panel

1

7

6

5

2

3

4

1

Fridge temperature colder button

2

Fridge temperature warmer button

3

ON/OFF button
OK button

4

Freezer temperature warmer button

5

Display

3) If a water connection is foreseen

Control panel

5